Harbor Freight Tools 3029 - Manual (Page 2)

Page 2 SKU 03029 For technical questions, please call 1-800-444-3353.
ASSEMBLY INSTRUCTIONS
1. To avoid accidental short circuits, disconnect the negative (-) terminal of the vehicle battery prior to
assembling the Off Road Truck Light System.
2. NOTE: The Halogen Lamps may be mounted above or below the front bumper. Make sure the desired
mounting location does not obstruct the vehicle’s headlights or turn signals.
3. Place the Halogen Lamps on the bumper, and mark the desired mounting locations at an equal
distance from the center of the bumper.
4. Where pre-marked, drill a 3/8” hole through the bumper. Then, mount the Halogen Lamps using the
hardware provided. NOTE: Make sure no electrical wires or cables are in the way of the drilling path.
(See Figure A.)
5. Mount the Light Switch in a location that is within easy reach
(i.e., dashboard, console). With the Light Switch in the desired
position, mark the holes for drilling and drill two 1/16” holes.
Then, mount the Light Switch with the Screws provided.
6. Connect the Red Wire of the passenger side Lamp to the 4 ft.
Red Extension Wire. (See Figure B, next page.)
7. Connect the 4 ft. Red Extension Wire to the “Y” Connector of
the 12 ft. Red Extension Wire. (See Figure B.)
8. Connect the Red Wire of the driver side Lamp to the “Y” Con-
nector of the 12 ft. Red Extension Wire. (See Figure B.)
9. Connect the Black Ground Wire from each Lamp (using the
Screws provided) to the chassis of the vehicle or any other
grounded metal surface. (See Figure B.)
10. Route the 12 ft. Red Extension Wire along the vehicle’s existing wiring, on the side of the engine
compartment, through the existing hole in the firewall, to the previously installed Light Switch. (See
Figure B.)
11. Connect the 12 ft. Red Extension Wire to the Light Switch terminal #2. (See Figure B.)
12. Connect the Black Ground Wire to the Light Switch terminal #4 and the other end of the Black
Ground Wire (using the Screws provided) to the chassis or any other grounded metal surface.
(See Figure B.)
13. Connect one end of the Blue Power (Hot) Wire to the Light Switch terminal #1 and the other end of the
Blue Power (Hot) Wire to a (+) 12 Volt power source at the fuse box or the (+) terminal of the vehicle’s
battery. (See Figure B.)
14. Use plastic tie-strips (not provided) to secure the wiring throughout the vehicle. Make sure to avoid
hot areas and moving par ts. Also, tape all connections using electrical tape (not provided). Protect
the wiring from sharp edges with tape or grommets.
15. Once assembly is complete, reconnect the (-) terminal of the vehicle’s battery and turn on the Light
Switch to ensure the Off Road Truck Light System is properly operating.
UNPACKING
When unpacking, check to make sure all the parts shown are included. If any par ts are missing or
broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
3/8”
HOLE
LOCK WASHER
FIGURE A
NUT
FLAT
WASHER