In-stand sensor mode (4600r only), Scan stand mode – HandHeld Entertainment 4600r User Manual
Page 53
3 - 5
Low Power Time-Out Timer
Scan the Low Power Time-Out barcode to change the time-out duration (in sec-
onds). Then scan the time-out duration (from 0-300 seconds) from the inside
back cover, and
Save
.
Default = 120 seconds.
If the unit remains idle during the low power time-out interval, the unit goes into
low power mode. Whenever the trigger is enabled, the low power time-out timer
is reset.
Note: This time-out does not begin until the imager time-out setting has expired.
In-Stand Sensor Mode (4600r only)
The 4600r (Software revision 31205480-118 or higher) contains a sensor that
senses when the imager is removed from the stand (HFSTAND5RSE only).
Refer to the
for information on determin-
ing the software in your unit.
The imager then enters Manual Trigger mode. If
you wish to turn the sensor on, scan the Sensor ON barcode below. Default =
Off.
Scan Stand Mode
Note: Scan Stand Mode is only available for non-advanced illumination units
with software revision 31205480-090 or lower. Refer to the
on page 11-2 for information on determining the
software in your unit.
Low Power Time-Out
Sensor On
* Sensor Off