HandHeld Entertainment 4600r - Manual (Page 94)

6 - 8
Scan Stand Mode
Note: Scan Stand Mode is only available for non-advanced illumination units
with software revision 31205480-090 or older. Refer to the Show
Software Revision on page 11-2 for information on determining the
software in your unit.
When a unit is in Scan Stand mode, it remains idle as long as it sees the Scan
Stand symbol. (See
Scan Stand Symbol that follows.) When a different code
is presented, the Imager is triggered to read the new code.
Note: The imager automatically adjusts the illumination LEDs to the lowest light
level possible to maintain a good lock on the Scan Stand symbol. When
a symbol is presented, the imager’s light levels adjust to the saved setting
(see
LED Power Level on page 3-9).
Scan Stand Symbol
When a unit is in Scan Stand mode, the LEDs shine at the Scan Stand symbol
on the base of the stand which tells it to remain idle.
When the Scan Stand
symbol is covered, the imager turns the LEDs on at the configured power level
(Default High) and attempts to find and decode barcodes in its field of view.
Presentation Mode
This programs the imager to work in Presentation mode. The LEDs are either
off or at the lowest power for ambient conditions until a barcode is presented to
the imager. Then the LEDs turn on automatically to read the code. Presenta-
tion Mode uses ambient light to detect the barcodes. If the light level in the
room is not high enough, Presentation Mode may not work properly.
Scan Stand Mode
Scan Stand Symbol
Presentation Mode