HoMedics Cool & Warm Mist Ultrasonic Humidifier HUM-WM75 - Manual (Page 5)

8 9
1. To release the tank from the unit, place your
fingers with your palm facing upward into the
recess in the tank handle. Press the tank release
button with your thumb.
2. Pull the water tank away from the humidifier base
by the handle and remove the water tank from the
base by lifting it up and away.
3. Turn the tank upside down – remove the tank cap
by turning it counter-clockwise.
4. FIll the water tank with clean, cool (not cold) tap
water. We recommend using distilled water if you
live in a hard water area.
5. Replace the tank cap by turning clockwise
until tight.
6. Install the tank back on the base of the unit. Make
sure the tank is firmly seated in the base.
7. Press the tank handle into the base of the
humidifier. You will know that the tank is locked into
place when the locking mechanism clicks and the
tank release button is in a raised position.
Oscillation
When the humidifier is producing mist, press the OSCILLATION ON/OFF ( ) button
to turn on the motorized oscillation feature. The nozzle at the top of the unit will
oscillate in a 120° range from side to side. To target the nozzle and mist in a fixed
direction, press the OSCILLATION ON/OFF ( ) button when the nozzle is at the
desired position and the nozzle will stop and direct mist to the desired area only.
(Fig.2)
NOTE: The oscillation feature will not operate if the humidifying function is not
operating. Oscillation feature will only work when mist is being produced.
How To Fill
CAUTION: Before filling unit with water, turn power off and unplug unit from outlet.
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
Fig.8
Fig.9