Harbor Freight Tools Jumbo Universal Remote Control 65785 - Manual (Page 6)

SKU 65785 For technical questions, please call 1-800-444-3353. Page 6
Press and hold the Sleep Button for five sec- 3.
onds. The LED light will turn on.
Release the Sleep Button.
4.
Using the number keys, enter the desired 5.
time in minutes (from 1 to 99). To set the
Timer to time that is under ten minutes, press
“0” and then the desired number (“05” for five
minutes.) The LED light will blink with each
pressed key.
Once the second number is entered, the LED
6.
turns off and the Sleep Timer is not set.
please note:
7. If you press any keys other
than the numbers, they will be ignored. You
will have ten seconds to program the Sleep
Timer, otherwise the LED light will blink four
times and exit the program.
Be sure to leave the Remote aimed at the
8.
TV. Once the Sleep Timer is set, you can
continue to use the Remote without altering
the Sleep Timer.
Please remember that the Remote must
9.
remain in TV mode for the Sleep Timer to
activate.
To cancel the Sleep Timer, press and release
10.
the Sleep Button and the Power Button. This
will reset the program to zero. The LED light
will flashing, stating the time has been reset
to Zero.
record serial number here:
note: If product has no serial number, record
month and year of purchase instead.
note: No replacement parts are available.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
please read the FolloWIng careFullY
THE MANUFACTURER AND/OR DISTRIBUTOR
HAS PROVIDED THE PARTS LIST AND
ASSEMBLY DIAGRAM IN THIS DOCUMENT AS
A REFERENCE TOOL ONLY. NEITHER THE
MANUFACTURER OR DISTRIBUTOR MAKES
ANY REPRESENTATION OR WARRANTY OF
ANY KIND TO THE BUYER THAT HE OR SHE
IS qUALIFIED TO MAKE ANY REPAIRS TO THE
PRODUCT, OR THAT HE OR SHE IS qUALIFIED
TO REPLACE ANY PARTS OF THE PRODUCT.
IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR ExPRESSLY STATES THAT
ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED
AND LICENSED TECHNICIANS, AND NOT BY
THE BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.