Hitachi VT-FX600A - Manual (Page 36)

TIMER RECORDING - 36 -
TO CORRECT AN AUTOMATIC TIMER PROGRAM
If you want to correct an automatic timer after you finished setting program,
1) Repeat steps [1] to [3] on previous page.
2) Select a digit you want to change using SELECT button or ADD/DELETE button.
3) Enter correct numbers using CH or button.
4) Press MENU button to return to original mode.
5) Press POWER button to return to timer stand-by mode.
TO STOP AN AUTOMATIC TIMER PROGRAM WHICH HAS ALREADY
STARTED
Press STOP/EJECT button on the VCR.
NOTE: STOP button on the remote control will not function in the Automatic Timer Recording mode.
TO CANCEL OR CHECK THE START/END TIME
1) Repeat steps [1] to [2] previous page.
2) Select a program number you want to check using CH or button. The details of selected program
appears on the TV screen.
You may cancel the entire program by pressing ADD/DELETE button.
HINTS FOR TIMER RECORDING
• If there is a power failure or the VCR is unplugged for more than 30 seconds, the clock setting and all timer
settings are lost.
• If the tape runs out before the end time, the VCR will switch to the Stop mode immediately, eject the tape and
the VCR power will be turned off. The " " indicator will flash.
• If a tape is not inserted or the erase-protection tab is removed, the " " indicator flashes and automatic timer
recording cannot occur. Insert a tape that allows recording.
• The TV that is connected to your VCR may be turned ON or OFF when the VCR is in the timer-record mode.
• When you record a cable channel program with cable converter box, first set the VCR's channel to 3 or 4
whichever is the output channel of your cable box to the channel you want to record and leave on while you are
recording with power on.
AUTO RETURN
If you select auto return to [AUTO] from the menu, when all the timer recordings are completed, the VCR will
return to the beginning of the recorded program(s).
NOTE: If there are any remaining programs including Daily & Weekly, this function does not be done.
1 Select the main menu
Press MENU button.
2 Select "VCR SET UP"
Press CH or button repeatedly to point to "VCR SET UP".
Then, press SELECT button.
3 Select "AUTO RETURN"
Press CH or button repeatedly to point to "AUTO RETURN".