Hearth and Home Technologies Heat & Glo SL-550TR-D - Manual (Page 27)

27
Heat & Glo • SL-550 / 750 / 950TR-D • InD • 2044-985 Rev. M • 10/06
Figure 7.7 To attach the fi rst section of vent pipe, make
sure to use the fi berglass gasket in the manual bag to seal
between the fi rst vent component and the outer fi replace
wrap. Use 2 self tapping screws to secure the gasket to
the outer wrap.
Secure the fi rst section of venting to the fi replace by
screwing through the two tabs bent up out of the vent
hole in the heat shield. Note: Once the vent cap has been
removed, it cannot be reattached.
B. Rear Vent
Figure 7.8 Fold the tabs toward the center of the fi re plug
(90°) and remove the insulation gasket.
Figure 7.7 Cut the metal retaining band and fold the sides
out.
Figure 7.10 Fold the center parts of the retaining band out
and use to remove the vent cap.
Figure 7.9 Discard the vent cap, remove and discard
the insulation basket. Note: Once the vent cap has been
removed it CANNOT be reattached.
Figure 7.10 Attach the fi rst vent section (it will snap into
place). Slide the insulation gasket onto the vent section,
up against the appliance and over the tabs.