HP 5992-3838 - Manual (Page 56)

amgrd
NAME
amgrd -- Change Behavior of HP Application Discovery Agent on Managed System
SYNOPSIS
Path: /opt/amgr/bin/amgrd [options]
amgrd [-start] [-noreload ]
amgrd [-connectionstatus]
amgrd [-enableRestart]
amgrd [-enableRestart] [-start ]
amgrd [-enableRestart] [-stop ]
amgrd [-disableRestart]
amgrd [-disableRestart] [-start ]
amgrd [-disableRestart] [-stop ]
amgrd [-procfreq interval{s|m|h}]
amgrd [-packfreq interval{s|m|h}]
amgrd [-ping]
DESCRIPTION
The amgrd command allows you to interact with an HP Application Discovery agent to start or
stop its operation, to change its mode of operation, to collect information about it, and to change
its data collection frequency on the system where it resides. You will need root access to use
this command.
You can also execute amgrd from the HP SIM graphical user interface by following the Configure
> Configure VSE Agents menus to HP Application Discovery options such as “Start AD Agents”
or “Stop AD Agents”.
Options
If no options are specified, the agent will start as a daemon with communication type of WBEM,
as these are the command defaults. The agent will then look for configuration options in a file
/var/opt/amgr/agent.properties
and run. If /var/opt/amgr/agent.properties
does not exist or does not contain a server.name property, then the agent will run, but it will
not know the location of the CMS to which it should send data.
The amgrd command recognizes the following options.
-config f Use configuration file f instead of default file.
-configfreq interval{s|m|h} Set configuration check frequency to a number t, with s
for seconds, m for minutes, or h for hours.
-connectionstatus Check status of the HP Application Discovery agent.
-disableRestart By itself, -disableRestart removes any inittab entry
for amgrd and exits.
With -start, amgrd removes any inittab entry for
amgrd
and runs the agent.
With -stop, amgrd removes any inittab entry for
amgrd
and stops the agent.
-enableRestart By itself, -enableRestart adds an inittab entry for
amgrd
and exits.
With -start, amgrd adds an inittab entry for amgrd
and runs the agent.
With -stop, amgrd adds an inittab entry for amgrd
and stops the agent.
56 Commands for Controlling HP Application Discovery Agent and Certificates