Harbor Freight Tools Metal Cutting Bandsaw 97099 - Manual (Page 14)

Page 14 SKU 97009 For technical questions, please call 1-800-444-3353.
A
D
B
FIGUrE F
TO ADJUST THE STOp BLOCk
For repeated cuts of pre-set lengths
Loosen the Thumb Screw (3) that holds the Stop Block (41) to the Stock Stop
Rod (40). (See Figure G)
Adjust the Stop Block (41) to the desired length position. Then re-tighten the
Thumb Screw (3). (See Figure G)
1.
2.
FIGUrE E
THE pOSITION FOr AN ANGLE (90°) CUT.
A
D
B
Setting up the Quick Vise for cutting a 12” workpiece:
Remove both fasteners from the Rear Vise Jaw (22).
Position (B) over the outer threaded hole on the Base (1).
Position Slot (A) over the small rectangular opening across the Base (1).
Attach Screws (A and B). Align the lower edge of the Rear Vise Jaw (22) with
the “0” index mark adjacent to the 1° degree setting. Tighten the screws.
(See Figure F)
.
•
•
•
•