Harbor Freight Tools PACIFIC HYDROSTRAR 97005 - Manual (Page 6)

Page 6 SKU 97005 For technical questions, please call 1-800-444-3353.
equipment for a purpose for which it
is not intended.
Never operate the Pressure Washer
22.
using a pulsing action. Pulsing is
the repeated and rapid ON and
OFF operation of the Trigger. This
action could result in the failure of
components and connections that are
under pressure.
This is a clean, cold water Pressure
23.
Washer. The working temperature
range must be between 41°
Fahrenheit and 104° Fahrenheit.
The water supply pressure must not
exceed 58 PSI and must be clean
and free of any abrasive particles or
corrosive contaminates.
Do not direct the water jet at live
24.
electrical equipment or the Pressure
Washer itself.
do not direct the water jet at
25.
yourself, others or pets.
Do not use the Pressure Washer to
26.
pump gasoline, kerosene, or any
other flammable or corrosive liquids.
Do not leave the Pressure Washer
27.
unattended while the machine is
running.
Never allow the Pressure Washer to
28.
run for more than two minutes with
the Spray Gun in its closed position.
Do not allow the Pressure Washer
29.
to run dry, as this will cause serious
damage to the Seals and Pump.
WARNING:
30. The brass components
of this product contain lead, a
chemical know to the State of
California to cause birth defects (or
other reproductive harm). California
Health & Safety Code 25249.5, et
seq.
Always ensure all water pressure is
31.
released and the Pressure Washer
is turned off before attempting to
disconnect any Hoses or Connectors.
This Pressure Washer is rated for
32.
domestic use only and should not be
used for professional or commercial
purposes.
Use caution when cleaning a vehicle
33.
to prevent damaging the finish with a
high pressure water stream.
SERvIcE PREcAUtIONS
before service, maintenance, or 1.
cleaning:
turn the engine switch to its a.
“OFF” position.
Allow the engine to completely
b.
cool.
then, remove the spark plug
c.
wire(s) from the spark plug(s).
Keep all safety guards in place and in 2.
proper working order. Safety guards
include muffler, air cleaner, mechani-
cal guards, and heat shields, among
other guards.
do not alter or adjust any part of
3.
the equipment or its engine that is
sealed by the manufacturer or dis-
tributor. Only a qualified service
technician may adjust parts that
may increase or decrease gov-
erned engine speed.
Wear ANSI-approved safety goggles,
4.
heavy-duty work gloves, and dust
mask/respirator during service.