Harbor Freight Tools 68298 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. SKU 68298
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY
INFORMATION section at the beginning
of this manual including all text
under subheadings therein before
set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and
unplug the tool from its electrical outlet before
adjusting tool or installing accessories.
1. (Explain how to adjust all the tool’s settings, install
and change accessories along with proper accessory
use, and test the tool on scrap work pieces)
Work Piece and Work Area Set Up
1. Designate a work area that is clean and well-
lit. The work area must not allow access by
children or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose work pieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General Operating Instructions
1. Make sure that depth adjustment
knob is tight before operation.
2. Set front end of the Base Plate (47) down against
the tile surface without the blade touching the saw.
3. Press the Power Switch (4) to turn on Tile Saw.
4. Allow Tile Saw to reach full speed before beginning
to cut.
5. Slowly slide Tile Saw forward, beginning to cut. See
Figure 4, below.
WARNING! If cutting into tile that is 3/4” or
thicker, you will need to make two separate cuts.
This will help prevent wear on the motor.
6. For continuous operation, press the Power
Switch and then press the trigger lock switch
on the side of the handle. Press trigger lock
switch again to release the trigger lock.
7. Release Power Switch to turn off Tile Saw.
8. To prevent accidents, turn off the tool and disconnect
its power supply after use. Clean, then store the tool
indoors out of children’s reach.
Figure 4