Fuel, Engine oil, Handlebar folding – HONDA HRX217HXA User Manual

Page 15: Placing in storage, Warning

Advertising
background image

15

Fuel

Gasoline will oxidize and deteriorate in storage. Old gasoline will
cause hard starting, and it leaves gum deposits that clog the fuel
system. If the gasoline in your mower deteriorates during storage, you
may need to have the carburetor and other fuel system components
serviced or replaced.

The length of time that gasoline can be left in your fuel tank and
carburetor without causing functional problems will vary with such
factors as gasoline blend, your storage temperatures, and whether
the fuel tank is partially or completely filled. The air in a partially filled
fuel tank promotes fuel deterioration. Very warm storage
temperatures accelerate fuel deterioration. Fuel deterioration
problems may occur within a few months, or even less if the gasoline
was not fresh when you filled the fuel tank.

The Distributor’s Limited Warranty (page 19) does not cover fuel
system damage or engine performance problems resulting from
neglected storage preparation.

You can extend fuel storage life by adding a gasoline stabilizer that is
formulated for that purpose, or you can avoid fuel deterioration
problems by draining all the fuel from the fuel tank and carburetor.

Adding a Fuel Stabilizer

When adding a fuel stabilizer (page 19), fill the fuel tank with fresh
gasoline. If only partially filled, air in the tank will promote fuel
deterioration during storage. If you keep a container of gasoline for
refueling, be sure that it contains only fresh gasoline.

1. Add fuel stabilizer following the manufacturer’s instructions.

2. After adding a fuel stabilizer, run the engine outdoors for

10 minutes to be sure that the treated gasoline has replaced the
untreated gasoline in the carburetor.

3. Turn the engine OFF and turn the fuel valve to the OFF position

(page 6).

Draining the Carburetor and Fuel Tank

1. Make sure the fuel valve is OFF (page 6). Remove the carburetor

drain bolt with a 10 mm wrench, and drain the fuel from the

carburetor bowl into an approved container.

If you only need to drain the carburetor, skip to step 3.

2. To drain the fuel tank, turn

the fuel valve ON (page 6).
This will allow fuel in the
fuel tank to drain out
through the carburetor
bowl.

3. After the fuel is completely

drained, reinstall the drain
bolt.

Engine Oil

Change the engine oil (page 11).

Engine Cylinder

1. Remove the spark plug

(page 12).

2. Pour a tablespoon

(5 ~ 10 cc) of clean engine
oil into the cylinder. This will
prevent rust from
developing inside the
engine.

3. Pull the starter rope several

times to distribute the oil in
the cylinder.

4. Reinstall the spark plug.

5. Pull the starter rope slowly

until resistance is felt, and
then return the starter grip gently. This will close the valves so
moisture cannot enter the engine cylinder.

Handlebar Folding

The handlebar can be folded for storage or transport by unlocking the
handlebar adjust knobs.

1. Remove the grass

bag. You can place it
on top of the engine,
with the bag opening
to the front.

2. Unlock the handlebar

adjust knobs, then
swing the handlebar
forward. Prevent the
cables from getting
pinched or kinked.

When unfolding the handlebar, be sure to lock the adjust knobs to
secure the handlebar in the mowing position.

PLACING IN STORAGE

If your mower will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapor
ignition. Select a well-ventilated storage area away from any
appliance that operates with a flame, such as a furnace, water heater,
or clothes dryer. Also avoid any area with a spark-producing electric
motor or where power tools are operated.

If possible, avoid storage areas with high humidity because humidity
promotes rust and corrosion.

Make sure the fuel valve is in the OFF position to reduce the
possibility of fuel leakage.

Place the mower with its wheels on a level surface. Tilting can cause
fuel or oil leakage.

The handlebar can be folded for compact storage.

With the engine and exhaust system cool, cover the mower to keep
out dust. A hot engine and exhaust system can ignite or melt some
materials. Do not use sheet plastic as a dust cover. A nonporous
cover will trap moisture around the mower, promoting rust and
corrosion.

WARNING

Gasoline is highly flammable and explosive.

You can be burned or seriously injured when handling
fuel.

• Stop engine and keep heat, sparks, and flame away.

• Handle fuel only outdoors.

• Wipe up spills immediately.

DRAIN BOLT

SPARK
PLUG
HOLE

OIL

Advertising
This manual is related to the following products: