Harman-Kardon HKTS30SAT-2 - Manual (Page 4)

4
5. If you’re not running the speaker wire through the wall, insert
it through the wall portion of the wall-mount bracket, as
shown in the illustration.
6. Pass the speaker wire through the speaker portion of the
wall-mount bracket, as shown in the illustration.
Bring wire in
through here
Bring wire out
through here
7. If you have not already removed the speaker’s base, do so by
pulling it straight off the speaker, as shown in the illustration.
Applying even pressure to both sides of the base will allow it
to slide off smoothly.
CAUTION: Before making speaker connections, be sure
that your receiver or amplifier is turned OFF and,
preferably, its AC cord is unplugged from the AC outlet.
Apply pressure evenly
to both sides of base
Lift base straight
off speaker
8. Connect the speaker wire to the speaker terminals, as shown in
the illustration:
• Press down on the top of the terminal to open the connection hole.
• Insert the wire’s bare end all the way into the hole.
• Release the terminal to secure the wire.
Insert the conductor with the colored band into the speaker’s
red ( + ) terminal, and insert the other conductor into the speaker’s
black ( – ) terminal.
IMPORTANT: Make sure the ( + ) and ( – ) bare wires do not touch
each other or the other terminal. Touching wires can cause a short
circuit that can damage your receiver or amplifier.
+
–
Push down on cap
to open hole
Insert bare wire
into open hole
Release cap
to secure wire
10. Slide the speaker onto the wall-mount bracket’s wall section,
as shown in the illustration. Pull any slack speaker wire back
through the wall-mount bracket's wall section.
11. Fit the metal stop plate into the recess on the bottom of the
wall-mount bracket with the pad facing the bracket, and
fasten it to the bracket using two of the supplied
screws. Fastening it will prevent the speaker from detaching
from the wall-mount bracket and will hold the speaker in
position as you rotate it on the wall-mount bracket.
Slide speaker
onto wall-mount
bracket
Stop plate
Supplied screws
9. Slide the speaker portion of the wall-mount bracket onto the speaker, as
shown in the illustration. Fit the wall-mount bracket’s grooves onto the
rails in the speaker, and apply even pressure on both sides of the wall-
mount bracket so it slides straight onto the speaker.
• Push the wall-mount bracket all the way onto the speaker until it
snaps into place.
• Pull any slack speaker wire back through the wall-mount bracket
as you slide the wall-mount bracket onto the speaker.
Fit bracket grooves
onto speaker rails
Push down evenly on both sides of wall-mount bracket
NOTE: If you’re running the speaker wire through the wall, you can
bring it out directly behind the wall-mount bracket’s location and insert
it through the bottom opening in the wall portion of the wall-mount
bracket, as shown in the illustration. Inserting it will keep the wire
completely hidden from view once the installation is complete.
Insert wire into
bottom opening
Bring wire out
through here