HoMedics SoundSpa SS-7000 - Manual (Page 7)

Using Auto-Timer
While listening to your iPod, the nature sounds, or the radio, you may set a
timer so the unit will automatically turn off.
1. Toggle through the TIMER BUTTON until the corresponding blue LED light
illuminates next to the time of your choice, 15, 30, 45, or 60 minutes (Fig. 1).
2. To cancel the timer, toggle through the TIMER BUTTON until the blue
LED light is not illuminated, which indicates you are at the off position.
Setting And Using The Alarms
Setting Alarm1 or Alarm2 (Individually)
1. Slide the ALARM SWITCH located on the back of the unit to AL1or
AL2 (Fig. 4). The AL1 or AL2 ICON will appear in the upper left hand
corner on the LCD display to indicate which alarm is activated (Fig. 2).
2. Press the AL SET BUTTON twice; hour digits will begin flashing (Fig. 1).
Turn the SET +/- KNOB until the desired hour is displayed (Fig. 1).
Remember to set the correct AM or PM (an icon to the left of the time dis-
play is the PM INDICATOR; there is no AM indicator) (Fig. 2).
3. Press the AL SET BUTTON again; minute digits will begin flashing. Turn
the SET +/- KNOB until the desired minute is displayed.
4. Press the AL SET BUTTON again to exit the alarm setting mode or after
5 seconds the display will stop flashing to indicate the alarm is set.
Note: You can press the AL SET BUTTON at any time to review the
alarm setting.
5. Toggle through the AL MODE BUTTON until the corresponding blue
LED light illuminates next to the wake mode of your choice, iPod,
sound, radio, or beep (Fig. 1).
Note: To wake to iPod, your iPod must be properly docked in the
unit, or it will default to beep wake mode.
Note: When using the sound mode, the unit will set to the last
sound you listened to. If you wish to change it, first, turn the power
on, then press the sound you wish to wake to. Lastly, turn the
power off.
6. When the alarm is sounding, press the POWER BUTTON on the unit to
turn the alarm OFF (Fig. 1). The alarm will come on again the next day
at the same time.
7. To stop the alarm from coming on the next day, slide the ALARM SWITCH
located on the back of the unit to the OFF position. The AL1 or AL2 ICON
will disappear on the LCD display to indicate the alarm is disarmed.
Note: If the alarm sounds for 30 minutes continuously it will
automatically turn off.
Setting Alarm1 and Alarm2 (Together)
1. Slide the ALARM SWITCH located on the back of the unit to
BOTH (Fig. 4). The AL1 and AL2 ICON will appear on the LCD
display to indicate both alarms are activated (Fig. 2).
Note: You cannot change the alarm time when BOTH is selected.
If you need to change the alarm time for either alarm, follow step 1
under Setting Alarm 1 or Alarm 2 (Individually).
2. Toggle through the AL MODE BUTTON until the corresponding blue LED
light illuminates next to the wake mode of your choice, iPod, sound, radio,
or beep (Fig. 1). Both AL1 & AL2 must wake to the same mode.
Note: To wake to iPod, your iPod must be properly docked in the
unit, or it will default to beep wake mode.
Note: When using the sound mode, the unit will set to the last
sound you listened to. If you wish to change it, first, turn the
power on, then press the sound you wish to wake to. Lastly,
turn the power off.
1 2 1 3
SS-7000_6.qxd 8/17/06 11:31 AM Page 13