Holmes HAP756 - Manual (Page 2)

OPERATING INSTRUCTIONS
1. Select location where air intake grill and filtered air
outlet are not obstructed.
2. Plug into a 120V AC electrical outlet.
3. The air purifier is now ready for use. Turn the unit on
by pressing the ( ) button (the air cleaner will turn
on to the highest setting). Select the desired operating
speed: High (4), Medium (3), Low (2) or Sleep (1) by
pushing the "+" or "-" buttons on the control panel.
For continuous use, it’s recommended to operate the air
purifier at the MEDIUM setting. For quieter operation or
use in a bedroom, select the LOW or Sleep setting. When
high levels of air pollution are present, select the HIGH
setting to quickly circulate and filter the room air.
CLEANING/MAINTENANCE
INSTRUCTIONS
1. Turn the air purifier off and unplug it before cleaning.
2. The outside of the air purifier can be cleaned with a
soft, clean damp cloth.
3. The filtered air outlet / top air vent can be cleaned of
dust with a small, soft brush.
4. If you wish to clean the inside of the air purifier, please
remove filters and only use a dry, soft cloth to wipe it
down.
5. DO NOT wash filters.
WARNING: Do not allow moisture to come in contact with
the main housing of the air purifier.
FILTER REPLACEMENT INSTRUCTIONS
1. On average, HEPA filters need to be replaced every
12-18 months. Carbon filters need to be replaced
every 3-6 months. Filter life will vary depending on air
quality and usage.
2. Turn off and unplug the air purifier before attempting
to replace the filters.
3. To access filter compartment, open front grill door by
placing fingers in the indentation on the right side of
the door, gently pull to the right before pulling forward
(see Figure 3).
4. Remove each of the filters from the unit by pulling
gently towards you.
5. To replace the carbon filter, simply remove the old
carbon filter and insert a new carbon filter in its place
after first removing the plastic bag. Using the plastic
tabs as a guildline (see Figure 1).
6. To replace the HEPA filter, discard the old HEPA filters. DO
NOT attempt to clean. Put the carbon filter back on the
new HEPA filter. Insert the new HAPF600 HEPA filter into
the unit, by sliding it onto the hang tabs (see Figure 4).
GET TO KNOW YOUR AIR CLEANER
Your true HEPA air cleaner removes up to 99.97% of airborne
allergens as small as 0.3 microns, including ragweed pollen,
grass pollen, tree pollen, household dust, dust mite debris,
mold spores, pet dander and smoke from the air passing
through the filter.
FEATURES
Dual Position
The air purifier can stand upright or lie on its side. Also
designed to fit with its back flush against the wall. When
positioning the unit, please be sure the air inlet grill, filters
and air outlet are not blocked to ensure maximum airflow.
Filter Window
On the front grill, there is a small
opening that will enable you to
see your carbon filter at a glance.
As it picks up dust and debris, the
window will turn to gray indicating the air purifier is
working and you may need to change the carbon filters.
HEPA Filter Indicator
When the HEPA filter is approaching the end of its useful life, the
indicator light will turn red. When the red indicator light starts
flashing, it is time to change the HEPA filter.
Carbon Filter Indicator
When the carbon filter indicator light turns yellow, it is time
to change the carbon filter.
Energy Star Rated
This product earned the ENERGY STAR by meeting strict
energy efficiency guidelines set by the US EPA. US EPA does
not endorse any manufacturer claims of healthier indoor air
from the use of this product. The energy efficiency of each
ENERGY STAR qualified model is measured based on a ratio
between the model’s CADR for Dust and the electrical energy
it consumes, or CADR/Watt.
Timer
The timer allows you to run your air purifier at your
convenience, for up to 16 hours. To operate using the timer
mode, at the control panel on the air purifier, turn the unit
on and select a speed.
To activate the timer, press the "+" and "-" speed buttons at the
same time for approximately 3 seconds.
The numbers in the display will begin flashing and the light will
appear to indicate timer function is on. Push “+” or “-” button to
cycle through the timer options (1-16). When you have reached
desired hours that you want your air purifier to run, release finger
from the button; the numbers will stop flashing, timer will be on,
and the screen will revert back to displaying a speed setting. The
air purifier will then operate for the selected period of time and
shut off automatically. Speeds can be changed once the timer is
activated by pushing the “+” or “-“ buttons. To view the time left
to run once timer has been set, push the “+” and “-“ at the same
time for 3 seconds. You can manually turn the air purifier off by
pressing the ( ) button once.
PRE-OPERATING INSTRUCTIONS
NOTE: The front grill should not be removed when the
unit is on its side.
1. After removing the unit from the box, take the plastic
covering off the unit and properly dispose of it.
2. Lay the air purifeir flat on its back with the front / air
intake grill pointing up.
3. Open the door of the air purifier by carefully placing
fingers in indentation on the right side of the door and
gently pull forward.
4. The carbon filters, which are packed in a plastic bag in the
box, should be removed from plastic bag and then placed
on each of the HEPA filters. The plastic tabs on the HEPA
filter will hold the carbon in place (see Figure 1).
5. Replace the front grill by aligning tab on left hand side and
swinging down. Gently press until front grill is firmly in place.
I M P O R TA N T S A F E G U A R D S
F E AT U R E S
SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock, and injury to persons. These precautions include:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance
directly into a 120V AC electrical outlet.
3. If the filter is covered by a bag when shipped, remove
plastic bag before use.
4. Keep the cord out of heavy traffic areas. To avoid fire
hazard, NEVER put the cord under rugs, near heat
registers, radiators, stoves, or heaters.
5. To protect against electrical hazards, DO NOT immerse
in water or other liquids. Do not use near water.
6. Close supervision is necessary when any appliance is
used by or near children, or disabled persons.
7. Always unplug the air purifier before moving or
cleaning the unit, opening the grill, changing the filters
and whenever the unit is not in use. To disconnect the
unit, be sure to pull the plug and not the cord.
8. NEVER drop or insert any objects into the openings of
the unit.
9. Do not operate any appliance with a damaged cord or
plug. If the motor fan fails to operate or the unit has
been dropped or damaged in any manner, return
appliance to manufacturer for examination and/or
repair.
10. Use appliance only for intended household use as
described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock, or
injury to persons. The use of attachments not recommended
or sold by the manufacturer may cause hazards.
11. DO NOT use outdoors.
12. NEVER place on a soft surface such as a bed or sofa as
this could cause the unit to tip over and block the air
inlet or outlet grills.
13. Keep unit away from heated surfaces and open flames.
14. DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed
by Jarden Consumer Solutions or an authorized
Jarden Consumer Solutions Center.
15. DO NOT place anything on top of unit.
16. NEVER use detergents, gasoline, glass cleaner, furniture
polish, paint thinner, or other household solvents to
clean any part of the appliance.
17. Always turn the appliance off before unplugging it.
18. This appliance should only be used in a room with
temperatures between 40° F and 110° F.
19. WARNING: To reduce the risk of fire or electric shock,
DO NOT use this air purifier with any solid-state speed
control device.
PLEASE SAVE THESE
IMPORTANT SAFETY
INSTRUCTIONS
PLUG SAFETY
CAUTION: To reduce the risk of
electric shock, THIS PRODUCT
HAS A POLARIZED PLUG (one
blade is wider than the other).
This plug will fit into a polarized
outlet only one way. If the plug does
not fit fully into the outlet, reverse
the plug. If it still does not fit, contact qualified electrician to
install the proper outlet. DO NOT ALTER THE PLUG IN
ANY WAY.
CORD SAFETY
• The length of cord used on this appliance was selected
to reduce tangling or tripping hazards.
• If a longer cord is necessary, an approved extension
cord may be used. The electrical rating of the extension
cord must be equal to or greater than the electrical
rating of the air purifier (see rating label marked on
product).
• Care must be taken to arrange the extension cord so
that it will not drape over the countertop or tabletop
where it can be pulled on by children or accidentally
tripped over.
O P E R AT I O N S ,
C L E A N I N G / M A I N T E N A N C E
Figure 2
A
B
C
D
F
E
A. SPEED CONTROL
B. FILTER LIFE INDICATOR
C. FILTER RESET
D. POWER BUTTON
E. FILTERED AIR EXHAUST GRILL
F. AIR INTAKE GRILL
R E P L A C E M E N T F I LT E R
Figure 1
A
B
A. HEPA FILTER
B. CARBON FILTER
A
C
B
D
7. After replacing the filters, RESET the Filter Life Indicator
by inserting a small object (such as a paper clip) into
the hole below the filter change light marked reset
( ). The red LED is the HEPA filter light and the
yellow LED is the carbon filter light.
REPLACEMENT FILTERS ARE AS FOLLOWS:
NOTE: Carbon and HEPA Filters are not washable and
should be replaced at the recommended intervals.
NOTE: Filters can be purchased at a retailer near you or
by calling 1-800-546-5637.
Figure 4
HANG TABS
Air Cleaner
Model
Number
Filter Quantity
Needed
HAP726-U 2
True HEPA
Filter
Filter
Model
Number
Filter
Description
HAPF600
HAP600D
B filter
HAP726-U 2
Carbon
filter
HAPF60
C filter
HAP756-U
HAP8756-U
3
True HEPA
Filter
HAPF600
HAP600D
B filter
HAP756-U
HAP8756-U
3
Carbon
filter
HAPF60
C filter
Figure 3
HAP8756_8EM2.qxd:127115/9100040002463 6/17/08 2:12 PM Page 2