Hayter Mowers RS 14/82 - Manual (Page 17)

GB
Mowing system
On the left hand site of the cutting deck is a connection for
an ½" water hose coupling.
The mowing system can be cleaned by connecting a water
hose.
During the cleaning process, the grass box or a
suitable accessory must be fitted.
1. Lower the mowing deck to the lowest cutting height.
2. Start the engine - set a medium engine speed.
3. Connect water hose.
4. Switch the mowing appliance on.
After a few minutes, the mowing system has been
cleaned.
5. Leave the mowing system to run for a few more minutes
in order to spin the water out.
6. Clean the grass box and leave to dry.
Checking by a qualified service agent is
necessary:
– after impact with an obstacle
– if the V-belt is defective
– if the engine comes to an immediate standstill
– if the brake performance drops
– if the blade is bent (do not straighten)
– if the drive belt slips
– if the blade shaft is bent (do not straighten)
– if there is a defect in the blade holder
– if there is damage to the transmission.
MAINTENANCE AND SERVICE
Maintenance, service and cleaning work may only be carried out when the machine has been turned off and has cooled down
and the ignition key has been removed.
The following tasks may be carried out by the user himself. All the other maintenance, service and upkeep tasks must be
carried out by a qualified service agent.
Before each
use
After each
use
After the
first 5 hours
After 25
hours of
operation
After 50
hours of
operation
Before each
storage
Check level of engine oil
„
Change engine oil
„ „
Clean the air filter
„
Replace the air filter
„
Check the spark plug
„
Check the brake
„
Check the tyre pressure
„
Check mowing blade
„
Check for loose parts
„ „
Check drive belt
„
Clean the lawn tractor
„
Clean air intake grille on engine
„ „
Clean grass and cuttings from transmission
„
For hydrostat drive:
Clean ventilator for transmission cooling „
)* see operating instructions of the engine manufacturer
In cases of high load and high temperatures, shorter maintenance intervals than those stated in the table may be necessary.
GB 17
43