Harbor Freight Tools 47003 - Manual (Page 10)

20. WARNING! People with pacemakers should consult their physician(s)
before using this product. Operation of electrical equipment in close proximity to
a heart pacemaker could cause interference or failure of the pacemaker.
21. WARNING! The warnings, precautions, and instructions discussed in this
manual cannot cover all possible conditions and situations that may occur. The
operator must understand that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
SKU 47003 PAGE 10
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagram on page 18.
To Remove Or Install A Cut-Off Wheel:
1. WARNING! Prior to performing any assembly procedures, make sure
the Power Cord (65) of the Cut-Off Saw is unplugged from its electrical
outlet. Also, make sure the Cut-Off Wheel has completely cooled and wear
work gloves while replacing the Wheel.
2. Place the Cut-Off Saw in its fully raised position. To do so, turn the Swing Lock
Handle (81) clockwise while pushing down on the Handle (66, 71).
(See Figure D, next page.)