Hitachi VT-FX602S - Manual (Page 28)

PRESET FOR USE - 28 -
5 Begin channel preset
Press SELECT button once. After scanning, the tuner stops on the lowest
memorized channel.
DAYLIGHT-SAVING TIME
Select this feature and the VCR's clock automatically will advance one
hour in April, then reverse one hour in October. Follow the steps below
when you want to use this feature even if you set the AUTO CLOCK to
ON.
When Daylight-Saving Time is ON, the clock's time will change
automatically as follows:
First Sunday of April : from 2:00AM to 3:00AM
Last Sunday of October : from 2:00AM to 1:00AM
NOTES:
• When programmed timer recordings start between 2:00AM - 2:59AM on the
First Sunday of April, the VCR will start recording at 3:00AM.
• When programmed timer recordings end between 2:00AM - 2:59AM on the First
Sunday of April, the VCR will stop recording at 3:00AM.
Make sure ...
• You must use the remote control for the following procedure.
• VCR power must be turned on.
• Turn on the TV and set the TV channel to the same video output channel
as located on the back of the VCR. (CH 3 or 4)
• Press VCR/TV button on the remote control so that "VCR" appears on
the display.
1 Select the main menu
Press MENU button.
2 Select "INITIALIZE"
Press CH/SET
or button repeatedly to point to "INITIALIZE".
Then, press SELECT button.
MENU
TIMER
PROGRAMMING
VCR SET UP
INITIALIZE