Harbor Freight Tools CAST IRON VERTICAL 93271 - Manual (Page 8)

SKU 93271 For technical questions, please call 1-800-444-3353. PAGE 8
InsPECtIon, MaIntEnanCE, and ClEanInG
WarnInG: Disconnect the Air Compressor from its electrical supply source before per-
forming any inspection, maintenance, or cleaning.
BEForE EaCH usE,
1. inspect the general condition of the Air Compressor. Check
all air fittings for leaks. Check for loose screws, misalignment or binding of mov-
ing parts, cracked or broken parts, damaged power cord and plug, and any other
condition that may affect the safe operation of this tool. If abnormal noise or vibra-
tion occurs, immediately disconnect the Air Compressor from its electrical supply
source and have the problem corrected before further use.
do not use damaged equipment.
daIlY: 2. Check the Air Compressor oil level. If necessary, fill with a premium qual-
ity, 30-weight, non-detergent oil. notE: When checking the oil level, make sure to
unscrew (do not pull) the Oil Breather (14B). (see assy. diagram B.)
daIlY:
3. Purge the Air Tank (9A) of all air and moisture to prevent corrosion. To do
so, slowly and carefully unscrew (no more than four threads) the Water Drain Valve
(10A) until the compressed air and condensation begins to be released from the Air
Tank. Allow sufficient time for all of the air and condensation to escape from the Air
Tank. Then, firmly retighten the Water Drain Valve. (see assy. diagram a.)
EVErY 100 Hours oF usE: 4. Clean the Air Filter (7A) with a mild solvent. Then,
dry and reattach the Air Filter. notE: Replace the Air Filter if it is too dirty to prop-
erly clean. (see assy. diagram a.)
EVErY 500 Hours or 12 MontHs: 5. Drain and replace the old oil with new, pre-
mium quality, 30-weight, non-detergent oil. When the Oil Drain (16A) is removed,
the old oil needs to be collected and disposed of in full accord with all applicable
waste disposal ordinances.
to ClEan 6. : wipe with a damp cloth, using a mild detergent or mild solvent.
WHEn storInG 7. : Keep the Air Compressor in a clean, dry location.
PlEasE rEad tHE FolloWInG CarEFullY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE
IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES
ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACE-
MENT PARTS THERETO.