Tsurumi TPG-2900H-DX - Manual (Page 52)

NOTE:
• Model TPG-2900H-DX uses four vibration mounts of two different part numbers. Two vibration
mounts of one part number are used to support the generator. Two vibration mounts of another part
number are used to support the engine. Refer to the Replacement Parts section for part numbers
and location.
• Model TPG-4300H-DX uses six vibration mounts of the same part number to support both the
engine and the generator. Refer to the Replacement Parts section for part numbers and location.
• Models TPG-6000H-DX and TPG-7000H-DXE use six vibration mounts of two different part num-
bers. Two vibration mounts of one part number are used to support the generator. Four vibration
mounts of another part number are used to support the engine. Refer to the Replacement Parts
section for part numbers and location.
(20) If vibration mounts (27 and 27.2) are being replaced, first install the mounts on frame (28)
as follows:
(a) Install engine vibration mounts (27) and secure to frame (28) with flanged nuts (26).
(b) Install generator vibration mounts (27.2) and secure to frame (28) with flanged nuts
(26).
(c) When used, install two spacers (27.1) over the two generator vibration mounts (27.2).
(21) Install assembled engine and generator as a unit over vibration mounts (27 and 27.2).
(22) Install flanged nuts (26) on the engine vibration mounts (27).
(23) Connect engine wiring from the front panel (29) according to the tags attached to the wires
during disassembly. (The engine wiring is in the cable that exits the control box (32).)
(24) Install the brush cover (10) and secure with two screws (11).
NOTE:
• A wiring access cover (brush cover) is provided only on Models TPG-4300H-DX, TPG-6000H-DX,
and TPG-7000H-DXE.
(25) Slip the flexible tube (12) in the hole in the rear cover (7) making sure the groove in the
tube is seated in the hole in control box (32) and rear cover (7).
(26) Connect engine wiring to the generator as required. (Refer to the Wiring Diagrams section.)
(27) Install front panel and control box (see Removal/Installation of Front Panel and Control
Box, fuel tank (see Replacement of Fuel Tank), and engine muffler (see Replacement of
Engine Muffler).
(28) Install four flanged bolts (21) to secure support bars (22).
Page 49 Removal/Installation
Tsurumi’s Operation, Service, and Repair Manual