Harbor Freight Tools HAUL MASTER 98511 - Manual (Page 4)

SKU 98511 For technical questions, please call 1-800-444-3353. Page 4
9. Slide Front Side Frames (2) and Back Side
Frames (3) together. Attach two Clamp
halves (13) over connected portion of the
Side and Back frames. Use Bolts (15), Nuts
(16) and Flat Washers (17) to fasten Clamps
over connected frames. See Figure 5, below.
10. Slide ends of Cab Bar (1) over ends of Front
Side Frames. Fasten Cab Bar to Frame tips
using Bolts (35), Nuts (36), Spring Washers
(37) and Flat Washers (38). See Figure 6,
below.
11. Place Center Bar (11) between Front or Rear
Side Frames. Please note: Center Bar is
adjustable and can be fastened anywhere
along Side Frames. Fasten Center Bar to
Side Frames using Bolts (24), Nuts (25) and
Flat Washers (26). See Figure 7, below.
12. The Truck Rack comes with four Coupler Ris-
ers (14) that allow you to raise height of Rack
another 6” if desired. Fasten Coupler Risers
to bottom of each Leg Stand using Bolts
(27), Nuts (28), Spring Washers (29) and Flat
Washers (30). See Figure 8, below.
13. Fasten Front (8L, 8R) and Rear (9L, 9R)
Mounting Feet to Coupler Risers, using Bolts
(27), Nuts (28), Spring Washers (29) and Flat
Washers (30). See Figure 9, below.
Please note: All Mounting Feet must be
installed with lips facing towards INSIDE of
bed truck. See Figure 9, below.
14. Please note: If lower Truck Rack height is
desired, Leg Stands can be fastened directly
to Front and Rear Mounting Feet without
Coupler Risers. Use Bolts (27), Nuts (28),
Spring Washers (29) and Flat Washers (30)
to fasten Leg Stand to Feet. See Figure 10,
below.
Figure 6
Cab Bar (1)
Front Side Frame (2)
Bolt (35)
Nut (36)
Figure 7
Center Bar (11)
Clamps (13)
Figure 8
Mounting
Foot (8R, 9L)
Leg Stand
Coupler Riser (14)
Bolt (43)
Figure 9
Mounting Foot (8R, 9L)
with lip facing inside
(Inside of truck bed)
Figure 10
Leg Stand
Mounting Foot (8R, 9L) Bolt (27)
Figure 5
Clamps (13)
Front Side
Frame (2) Back Side Frame (3)
REV 10c