HANNspree HF257 - Manual (Page 21)

User’s Manual
ERROR MESSAGE & POSSIBLE SOLUTIONS
CABLE NOT CONNECTED :
1. Check that the signal-cable is properly connected, If the connector is loose, tighten the
connector’s screws.
2. Check the signal-cable’s connection pins for damage.
INPUT NOT SUPPORT :
Your computer has been set to unsuitable display mode, set the computer to display mode given
in the following table.
FACTORY PRESET TIMING TABLE:
(Analog / Digital mode)
MODE RESOLUTION REMARK
1 640×350 @70Hz VGA
2 640×400 @56Hz VGA
3 640×400 @70Hz VGA
4 640×480 @60Hz VGA
5 640×480 @67Hz MAC
6 640×480 @70Hz VGA
7 640×480 @72Hz VGA
8 640×480 @75Hz VGA
9 720×400 @70Hz VGA
10 720x480@60Hz VGA
11 800×600 @56Hz SXGA
12 800×600 @60Hz SXGA
13 800×600 @70Hz SXGA
14 800×600 @75Hz SXGA
15 832×624 @74.6Hz MAC
16 1024×768 @60Hz XGA
17 1024×768 @66Hz XGA
18 1024×768 @70Hz XGA
19 1024×768 @75Hz XGA
20 1024×768 @75Hz MAC
21 1152×864 @75Hz SXGA
22 1152×870 @75Hz MAC
23 1152×900 @66Hz SUN66
24 1280×720 @60Hz
25 1280×768 @60Hz
26 1280×768 @75Hz
27 1280×960 @60Hz
28 1280×960 @75Hz
29 1280×1024 @60Hz SXGA
30 1280×1024 @72Hz SXGA
31 1280×1024 @75Hz SXGA
21