Hughes & Kettner CF 200 - Manual (Page 3)

CF
l
REAR PANEL FEATURES AND FUNCTIONS
( 0 ) Prior to plugging the factory-included EUROMAINS CABLE in the AC receptacle
off the rear panel, adjust the voltage selector to the correct voltage.
( 7 ) Use a screwdriver to remove the FUSE BRACKET. Ensure replacement fuses hear
identical specifications to the originals. The fuse bracket on the European model
doubles as a voltage selector. Read the upright value to determine the correct
voltage setting.
( 8 ) The GROUND LIFT switch severs the ground to the chassis, eliminating
annoying background hum when the power amp is used in conjunction with other
equipment.
( 9 ) SPEAKERS
Connect speakers to these jacks for stereo operation. When using one speaker
cabinet per channel, ensure each speaker has a minimum power rating of 100 watts
and an impedance between 4 and 16 ohms. For two speakers per channel, each
cabinet must be rated at 8 ohms or greater.
( 10 ) SPEAKER PROTECT
Two fuses (3.15 A), one for each channel, protect speakers from damage due to
malfunctions e.g. direct current in the output jack. They also protect the power amp
from potential damage, e.g.
due to a defective power cable.
Before resuming operation, ensure:
l
you replace blown fuses with ones hearing identical ratings.
l
both, the connected speakers and speaker cables are fully functional.
l
a qualified repairman inspects he CF 200 for possible damage.
( 6/7 ) (8) (9) (10)
page 8