Havis-Shields 2004-2008 Ford Econoline Van C-VS-1800-ECO - Manual

C-VS-1800-ECO_INST_9-07
INSTALL INSTRUCTIONS C-VS-1800-ECO
2004-2008 FORD ECONOLINE VAN
TOOLS REQUIRED:
3/8” Standard Socket Set
3/8” Metric Socket Set
3/8” Ratcheting Wrench Powered drill w/ drill bit set
Open-end wrench set
Screw driver set
HARDWARE & COMPONENTS:
QTY DESCRIPTION PART
#
6 ¼-20 Nylock nut GSM30016
4 ¼” Flat washer GSM31005
2 ¼-20 x ¾” Carriage bolt GSM32000
4 ¼-20 x 1 ¼” Hex head bolt GSM33003
4 #10 x 1” Phillips sheet metal screw GSM33196
1 Torx Screw Hardware Kit C-HK-1
Always !
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
INSTALL C-VS-1800-ECO:
1. Remove O.E.M. engine cover accessory package (cup holder/storage pocket).
2. Place new console housing with mount brackets against engine cover and
floor. Mark engine cover and drill four (4) - 5/16” diameter holes. Mark
outline of floor bracket.
Also remove
washers from studs