Harbor Freight Tools CentalPneumatic Coil Roofing Nailer 68024 User Manual

Page 5

Advertising
background image

Page 5

For technical questions, please call 1‑800‑444‑3353.

SKU 68024

SPECIFIC INSTRUCTIONS

1.

Operators and others in work area

MUST wear ANSI‑approved safety

goggles with side shields during use.

The employer is responsible to enforce

the use of eye protection by the operator

and others in the work area.

2.

Keep fingers away from trigger

when not driving fasteners to avoid

accidental firing.

3.

Choice of triggering method is

important. Check manual for

triggering options.

4. Always assume tool contains fasteners.
5. Do not point tool toward yourself or

anyone whether it contains fasteners

or not.

6. Do not actuate the tool unless the tool is

placed firmly against the workpiece.

7. Respect the tool as a working implement.
8. No horseplay. This tool is not a toy and

can be deadly if misused.

9. Do not load tool with fasteners when any

one of the operating controls, such as

Trigger or Safety Nosepiece, is activated.

10. Do not remove, tamper with, or otherwise

cause the tool operating controls to

become inoperable.

11. Do not operate if any portion of operating

controls is inoperable, disconnected,

altered, or not working properly.

12. Disconnect the tool from the air

supply when:

a. Unattended.
b. Performing any maintenance or repair.
c. Clearing a jam.

d. Moving the tool to a new location.

13. Do not make any modifications to tool.
14. Refer to the tool maintenance

instructions for detailed information on

the proper maintenance of the tool.

15. Fire fasteners into an appropriate

work surface only. Do not attempt to

fire fasteners into surfaces too hard to

penetrate. Do not drive fasteners on top

of other fasteners, or at too steep of an

angle. Fasteners can ricochet causing

personal injury.

16. Do not fire fasteners too close to edge of

a workpiece. They may split workpiece

and fly free, causing personal injury.

17. Keep clear of workpiece near the area

being fastened. Fasteners may bend

sideways during firing, causing them

to exit the workpiece at an unexpected

point, causing personal injury.

18. Transport tool safely. Always disconnect

air supply when moving tool. Carry tool

by handle and avoid contact with trigger.

19. Hold tool away from head and body.

During operation the tool may kick back

causing injury.

20. Do not fire fasteners into a workpiece

that has people, utility lines, or other

objects behind or inside it.

21. Keep balance while using this tool.

Keep area below clear if working in

an elevated location, and secure air

hose to prevent falls from bystanders

accidentally pulling on it.

22. Obey the manual for the air compressor

used to power this tool.

23. Install in-line shutoff valve to allow

immediate control over air supply in an

emergency, even if a hose is ruptured.

Specific Safety Instructions

Advertising