Heath Zenith Lighted Wireless Push Button Accessory - Manual (Page 6)

-6- 598-1137-02
Troubleshooting
Chime does not sound:
• Make sure push button and chime codes are the same (See pages 3,
4, and 5).
• Check orientation of push button battery (See page 5).
• Check charge of push button and chime batteries (if applicable), replace
if necessary.
Batteries seem OK, but the chime does not work when installed:
• Do not mount chime or push button on metal or near metal studs. This
reduces the transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood
shims to move chime or push button off metal surface.
• Concrete floors may reduce range. Move chime away from floor.
• Try locating chime closer to push button.
Push button light (LED) is “ON” or “OFF” all the time (see page 1).
The range of the wireless chime can vary with location, temperature and
battery condition.