Hitachi 32LD8800TA - Manual (Page 39)

36
ENGLISH
FUNCTION
Power Swivel
With the Desktop stand (included for 32LD8800TA, optional for 37LD8800TA), you can adjust the angle of the
monitor side to side by pressing
SWIVEL
button on the remote control.
1. Press
SWIVEL
button on the remote control.
The Swivel Display (as shown in the fi gure on the right) will appear on the
screen.
2. Adjust the angle of the monitor with ◄ ►keys while Swivel Display is on
the screen.
The monitor will be able to move ±30 degrees to each side.
NOTE
If the stand cable is not connected to the unit, the message “Not Available”
will appear on the screen.
The Swivel Display will automatically disappear when no operation has
been made for about 6 seconds.
The Swivel Display
Swivel
CAUTION
Do not push the panel with your hands while operating the Swivel. It could damage the panel and/or stand.
Do not allow children to play or hang on the TV. These actions may tip it over, causing personal injury.
Do not swing the monitor back and forth.
Do not place any fragile objects around the monitor. The monitor would hit the object(s) during the Swivel
operation and could cause the breakage of the objects and/or the stand.
To operate the Swivel function correctly, place the monitor on the stable surface.
When you use the unit as wall-mounting, disconnect the stand cable from the monitor before installation.
SWIVEL
button
Information
About Swivel terminal connection
CAUTION
When you install the Desktop stand, follow the Instructions of the Manual included with the stand.
Turn Off the Main Power of the monitor when connecting or disconnecting the stand cable to the unit.
To disconnect the stand from the unit.
Before detach the stand from the unit, make sure to
disconnect the stand cable
from the Swivel terminal on
the rear side of the unit.
POWE R SWIV EL
CAUTION
When you use the Power Swivel function, make sure that the Power Cord, cord
or chain connected to the wall is loose enough to operate the Swivel function
securely.
Do not put hands or faces near the monitor while operating the Swivel. It could
cause personal injury. Beware especially when small children are around the
monitor.
To connect the Desktop stand to the unit
Connect the designated stand cable to the Swivel
terminal on the rear side of
the unit.
POWER SWIVEL
30°
30°
Slack