Honeywell HZ-2204 - Manual (Page 4)

• Select the appropriate heat dispersion mode. (See
Set-Up instructions.)
• With the Power knob in the OFF position, plug the
heater into a polarized 120V outlet.
• Turn the Thermostat control fully clockwise to the
HIGH setting.
• Turn the heater on using the Child Resistant switch
(Power knob). To operate the switch, push down
the two sides of the Power knob while turning it
clockwise to the desired position (Fig. 2). The power
light will illuminate. The Child Resistant switch helps
ensure that the heater can not be turned on accidentally.
• When the room reaches a comfortable temperature, slowly turn the Thermostat
control counter-clockwise until the heater goes off. This is the point at which the
Thermostat setting equals the room temperature. At this setting, the Thermostat
will automatically turn the heater on and off to maintain this selected temperature.
• Push down and turn the Power knob to OFF and unplug the heater when you
are finished using it.
This heater is equipped with several devices and features for added protection.
• A tip-over switch that disables the heater if it is accidentally tipped
backwards or forwards. The heater will NOT be disabled if it rolls on its
sides.
• A high temperature safety control prevents overheating (HI limit).
• This heater is also equipped with motor thermal fuse that will shut down
the motor should it operate at a higher then normal temperature.
• This heater was created using a high quality safety plastic.
SAFETY FEATURES
OPERATING INSTRUCTIONS
PUSH & TUR
N
HIGH
OFF LOW
• •
• •
FAN
PUSH
PUSH
Fig. 2