Hanns.G HSG1040 - Manual (Page 20)

User’s Manual
ERROR MESSAGE & POSSIBLE SOLUTIONS
CABLE NOT CONNECTED:
1. Check that the signal-cable is properly connected, If the connector is loose, tighten the
connector’s screws.
2. Check the signal-cable’s connection pins for damage.
INPUT NOT SUPPORT:
Your computer has been set to unsuitable display mode, set the computer to display mode given
in the following table.
RECOMMENDED AND SUPPORTED TIMING MODE:
(Analog / Digital mode)
MODE RESOLUTION REMARK
1 640x350@70 Hz VGA
2 640x400@56 Hz VGA
3 640x400@70 Hz VGA
4 640x480@60 Hz VGA
5 640x480@67 Hz MAC
6 640x480@70 Hz VGA
7 640x480@72 Hz VGA
8 640x480@75 Hz VGA
9 720x400@70 Hz VGA
10 800x600@56 Hz SVGA
11 800x600@60 Hz SVGA
12 800x600@72 Hz SVGA
13 800x600@75 Hz SVGA
14 [email protected] Hz MAC
15 1024x768@60 Hz XGA
16 1024x768@66 Hz XGA
17 1024x768@70 Hz XGA
18 1024x768@75 Hz XGA
19 1024x768@75 Hz MAC
20 1152x864@75 Hz SXGA
21 1152x870@75 Hz MAC
22 1152x900@66 Hz SUN66
23 1280x720@60 Hz
24 1280x768@60 Hz
25 1280x768@75 Hz
26 1280x960@60 Hz
27 1280x960@75 Hz
28 1280x1024@60 Hz SXGA
29 1280x1024@72 Hz SXGA
30 1280x1024@75 Hz SXGA
31 1360x768@60 Hz WXGA
32 1400x1050@60 Hz WXGA+
33 1440x900@60 Hz WXGA+
20