HONDA HRR216PDA - Manual (Page 34)

SERVICING YOUR MOWER
32
Blade Removal and Installation
If you remove the blade(s), use a torque wrench for installation. Wear
heavy gloves to protect your hands. To avoid weakening the blade(s),
or causing imbalance or poor cutting, the blade(s) should be
sharpened by trained staff at an authorized Honda servicing dealer. If
replacing the blade, use a genuine Honda replacement blade(s) or
equivalent.
Blade Removal
1. Turn the fuel valve to OFF. Disconnect the spark plug cap, then tilt
the mower to the right side (carburetor side up).
2. Remove the two blade bolts with a 14 mm socket. Use a wooden
block to prevent the blade(s) from turning when removing the bolts.
Remove the blade(s) from the blade holder.
Always use an upper and lower blade on the HRR and HRZ models.
HRS BLADE HOLDER
SINGLE BLADE
SPECIAL
WASHER (2)
BLADE
BOLT (2)
HRR, HRZ
BLADE HOLDER
UPPER
BLADE
LOWER
BLADE
SPECIAL
WASHER (2)
BLADE
BOLT (2)