Heath Zenith SL-5680 - Manual

© 2007 HeathCo LLC 598-1100-02
Mounting Plate
Ground
Screw
(A)
(B)
Fluorescent
Lamp
Lens
1. Select a location on a flat wall with a properly attached electrical
junction box.
2. Unscrew the lens. Set aside the lens and fluorescent lamp.
3. Remove the decorative nut. Remove the mounting plate.
4. Thread the junction box wires through hole (A) in the mounting
plate.
5. Make sure the arrow on the mounting plate is pointed up. See
which pair of holes in the mounting plate will line up for your
junction box. Secure the mounting plate to the junction box. The
two #8-32 screws provided should work with round or octagon
junction boxes. If you are using a small rectangular box, you
will need to purchase two #6-32 screws at least 1/2" long.
6. Secure the service ground wire under the head of the green
ground screw.
7. Connect the fixture wires to the service wires ( black to black
and white to white). Secure with wire nuts provided.
8. Make sure the wire nuts and wires are inside the fixture wiring
compartment. Secure the fixture body to the mounting plate
with decorative nut (B).
9. Plug in the 13 Watt fluorescent lamp provided.
10. Reinstall the Lens.
11. Caulk fixture mounting surface with silicone weather sealant.
To test operation during daylight, cover the photocontrol window
with black tape. Turn on the power. The photocontrol has a time
delay (up to 2 minutes) before it will respond to light changes. The
light will take up to five minutes to reach full brightness. Uncover
the photocontrol and your unit will operate automatically—on at
dusk, off at dawn.
Photocontrol
No Service Parts Available for this Product
Fluorescent Outdoor
Security Light
Installation Instructions
READ ALL INSTRUCTIONS CAREFULLY BEFORE BEGINNING INSTALLATION.
NOTE: All wiring must be run in accordance with the National Electrical Code (Canadian Electrical Code in Canada) through
conduit or another acceptable means. Contact a qualified electrician if there is any question as to the suitability of
the system.
Model SL-5680
WARNING: Turn power off at the fuse or circuit
breaker.
Lamp in Fixture Contains Mercury. Dispose According
to Local, State, or Federal Laws.