Heath Zenith Motion Sensing Post Light Adapter SL-4100 - Manual (Page 2)

2 595-5657-04
INSTALLATION
4. Twist the wires from the post and the
bottom sensor wires together as shown.
Secure with wire connectors provided.
5. Make sure the wires and connectors are
all inside the post, then set the sensor
onto the post.
6. Start and temporarily tighten the three
screws previously removed from the sen-
sor.
7. Twist the wires from the fixture and the top
sensor wires together as shown. Secure
with wire connectors saved from your
fixture.
8. Make sure all the wires and connectors
are inside the fixture/sensor wiring com-
partment. Set your coach light onto the
sensor and proceed to the adjustments
on the next page.
1. On existing installations, remove the light
from the top of the post. Keep the wire
connectors to make the connections to
the top of the sensor.
CAUTION: When handling the sensor be
careful not to pinch or distort the lens. You
may break the seal and cause windblown
rain to enter the sensor.
DUSK TO DAWN
6 HOUR
3 HOUR
OFF
20
5
1
TEST
ON TIME
MINUTES
ACCENT
MAX
MIN
SENSITIVITY
ON-TIME Switch at 1,
5, or 20 minutes
Mode Switching Summary
Flip light
switch off for
one second
then back on*
MANUAL MODE
AUTO
TEST
* If you get confused while switching modes,
turn the power off for one minute, then back
on. After the calibration time the control will
be in the AUTO mode.
D
ual
B
rite
® Dimmer Control
Light comes on half bright for selected time af-
ter dusk (Off, 3 hr., 6 hr., until dawn). Selecting
OFF disables this feature. The motion sensing
features will continue to work as described
in this manual. If motion is sensed, the light
turns on full bright for the ON-TIME (1, 5, or
20 minutes) then returns to dim mode.
WARNING: Turn power off at circuit
breaker or fuse.
2. Remove the three screws around the
bottom edge of the sensor. Save these
screws for later use.
3. Set the controls on the bottom as shown:
ON-TIME to TEST, D
ual
B
rite
® (ACCENT)
OFF, and Sensitivity to mid-position.