Horizon Fitness T71 - Manual

ASSEMBLY STEP 3-A
(T71 model)
ATTENTION!
There has been an update to the assembly process of your Horizon Fitness treadmill. Please refer to these
instructions for proper assembly. The remaining steps of the assembly process shall follow the original
procedures as found in the owner’s manual.
NOTE: If there are any alignment issues encountered in step C, please note that the right and left support
bars can be reversed to improve alignment. For example, the right support bar can be used on the left side
and vice versa.
If you experience any problems during this assembly process, please contact Horizon Fitness at
1.800.244.4192.
A Open HARDWARE BAG 3.
B Slide the HANDLEBAR EXTENSION
onto the CONSOLE HANDLEBAR.
You will need to slide the
HANDLEBAR EXTENSION under
the console assembly plastic by
slightly lifting the plastic in order
to attach the connection bolts.
C Insert BOLT (E) into HANDLEBAR
EXTENSION.
D Insert BOLT (F) and ARC WASHER
(D) through bottom hole of
HANDLEBAR EXTENSION into
CONSOLE MAST.
E Tighten all bolts.
F Repeat on other side.
BOLT (E)
12 mm
Qty: 2
BOLT (F)
15 mm
Qty: 2
angle view
ARC WASHER (D)
Qty: 2
top view
HARDWARE BAG 3 CONTENTS : T71
HANDLEBAR
EXTENSION
BOLT (F)
BOLT (E)
ARC WASHER (D)
CONSOLE MAST
CONSOLE
HANDLEBAR
T71
The CONSOLE PLASTIC ATTACH SCREW may need to be
loosened in order to slide the handlebar extension under
the console assembly plastic as described in step B. CONSOLE PLASTIC
ATTACH SCREW
ASSEMBLY STEP 4