HoMedics EnviraScape Tabletop Relaxation Fountain WFL-FLOR - Manual (Page 3)

Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is controlled by the switch
located at the front of the pump. The speed is indicated by a plus (+) and minus
(-) sign. To increase the speed, move the switch slowly to the left in the direction of
the plus sign. You will hear a click as the switch moves to each speed level. At its
highest speed level, the switch will cease to move any further. To decrease the pump
speed, move the switch to the right toward the minus sign. Similarly, at its lowest
speed, the switch will cease to move any further. (Fig 1)
NOTE: It is recommended the pump be set at its highest speed during assembly
and later adjusted to a lower setting if desired. Be sure to unplug the
pump before adjusting the speed setting.
3. Insert the black connector at the bottom of the plastic tube attached to the foun-
tain top into the round opening of the pump. (Fig. 2)
4. Insert waterproof light B into the light clip located inside the base (Fig. 3). Lights
should be facing upwards within light clip.
5. Align the notches located on the bottom of fountain top with tabs located on
base. Attach by moving from front to back (Fig. 4).
Note: Run the plastic tube into the base through the slot at the
back of the base.
6. Fill the base with clean water until the water level reaches top of light clip,
approximately 24 oz. (Fig. 3)
7. Place the screen on the base. (Fig. 5)
8. Attach the Adaptor to the power cord. (Fig. 5)
9. Plug the cord into 120V household outlet. The fountain is controlled by a
switch located on the power cord. If pump does not operate, rotate in-line
switch once to turn “on” and once to turn “off”.
Note: Ensure that the electrical cord loops below the electrical outlet
to form a “Drip Loop”. This will prevent water from running down the
electrical cord into the electrical outlet. (Fig. 6)
Minimum Water Level
Flow Control Lever
(+) faster water output
(-) slower water output
Attention:
In order to get
best results,
please operate
pump completely
submerged.
Keep the water
level above the
minimum water
level ALL THE
TIME.
Figure 1
4 5
Figure 2 Figure 3
Figure 4
Figure 5
Waterproof
Light A
Base
Waterproof Light B
Pump
Plastic
Tube
Middle
Tier
Waterproof
Light B
Base
Light Clip
Base
Tab
Notch
Base
Screen Switch
Power Cord
Adaptor
Water
Top Top
Back of
Top
Top
Top