Honeywell HCM-635 - Manual (Page 7)

P O W E R
CAUTION: DO NOT PLUG IN THE HUMIDIFIER WITH WET
HANDS AS AN ELECTRICAL SHOCK COULD OCCUR.
• With the power OFF, plug the filled humidifier into a polarized
120V outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE
OUTLET; it will only fit one way.
S T E P 1 : P O W E R
• Press the Power button to start the humidifier. Your humidifier
will automatically start on High power, Continuous Mode. The
display will be illuminated and will reflect the current room
humidity (Fig. 9).
• To turn your humidifier OFF simply press the Power button again.
Continuous Mode: Your unit will run continuously at your selected
output level until you shut it off or it runs out of water.
S T E P 2 : O U T P U T / F A N S P E E D C O N T R O L
Your unit has three output levels/fan speeds:
HIGH: For fast humidifying
MED: For everyday moisture control
LOW: For minimum operation (ideal for nighttime use)
• To change your fan speed press the fan speed button ( ) up or
down (Fig. 10).
• Once you have selected your desired speed the display will go
back to showing the current room humidity after 3 seconds.
NOTE: If you wish to change or check your output/speed setting
simply press the fan speed button (
) once and it will show you
your setting. If you would like to change it, continue to push the
button up or down until you have reached your desired setting.
Again, after 3 seconds the display will revert to showing the current
room humidity.
S T E P 3 : T I M E R C O N T R O L
• You can set your timer for up to 18 hours. This function should
only be used if you desire that the humidifier be automatically
shut off after a certain period of time.
• Press the Timer button ( ) up or down to set how many hours
you would like the humidifier to run (Fig. 11).
• When the display indicates your desired time, wait 3 seconds.
• After 3 seconds, your desired time is set and the display will
revert back to showing the current room humidity.
NOTE: If you wish to change your timer setting or check to see how much time is left, simply press the
Timer button (
) once and it will show you the time left. If you want to change the time remaining,
continue to push the button up or down until you have reached your desired time. Again, after 3 seconds
the display will revert to showing the current room humidity. If you set a timer but no longer wish to have
it set, turn the unit off and then repeat steps 1 and 2.
7
Digital EasySet ™ Control Operation (Model HCM-650)
Fig. 9
Fig. 10
Fig. 11
Humidistat
Control
Fan Speed
Control
Timer
Control
Desired
Humidity
Light
QuietCare_OM_Rev2.qxd 5/16/06 5:47 PM Page 7