Husky HU80522 - Manual (Page 11)

11
ASSEMBLY
ASSEMBLING THE SPRAY WAND
See Figure 5.
To attach the spray wand extension:
 Place the threaded end of the wand extension in the
connector on the end of the spray wand assembly.
 Turn the connector clockwise until it stops. This secures
the wand extension in place.
 When not in use, remove the spray wand extension from
the spray wand by turning the connector counter clock-
wise. Store
both pieces on top of the pressure washer.
CONNECTING HIGH PRESSURE HOSE TO
SPRAY WAND ASSEMBLY
See Figure 6.
 Screw the collar on the high pressure hose into the spray
wand’s inlet coupler by turning the hose collar clock-
wise.
 Pull on the hose to be certain it is properly secured.
Fig. 6
COLLAR
HIGH PRESSURE
HOSE
INLET
COUPLER
SPRAY
WAND
EXTENSION
CONNECTOR
SPRAY
WAND
GROOVED
GRIPPING
SURFACE
Fig. 5