Havis-Shields Slide-Out Trunk Tray 2006-2008 Chevrolet Impala C-3311-18-2 - Manual

- 1 -
INSTALL INSTRUCTIONS C-3311-2 & C-3311-18-2
SLIDE-OUT TRUNK TRAY
2006-2008 CHEVROLET IMPALA
TOOLS REQUIRED:
7/16” wrench
Powered drill w/ 3/16” drill bit
Ratcheting wrench
Standard socket set
Screwdriver set
HARDWARE:
QTY DESCRIPTION PART
#
12 ¼-20 x ¾” Hex head bolts GSM33001
16 ¼” Flat washers GSM31005
12 ¼-20 Serrated nuts GSM30023
4 8-32 x 3/8” Machine Screws GSM33540
4 8-32 Keps Nuts GSM30027
4 ¼” x ¾” Hex head lag bolts (only on C-3311-18-2) GSM33060-1
2 Front Mounting Leg CM001390
1 Rear Driver-side bracket CM001391
1 Rear Passenger-side bracket CM001392
4 Mounting plate w/ pem ¼” pem studs (Use 2 on C-3311-18-2) CM001393
1 P.S. Front Mounting Bracket (only on C-3311-18-2) CM001394
1 P.S. Rear Mounting Adapter Bracket (only on C-3311-18-2) CM93712
Always
!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html
SUB ASSEMBLY: (Use Iso views on page #1 & 2 for sub assemblies)