Holmes HAP706 - Manual (Page 2)

OPERATING INSTRUCTIONS
IMPORTANT:
• Remove all plastic bags from filters before use.
• DO NOT POINT FILTERED AIR OUTLET TOWARDS WALL.
To operate your air cleaner:
1. Plug into a 120V AC electrical outlet.
2. Select the operating speed of HIGH ( ),
MEDIUM ( ) or LOW ( ) by turning the speed
control knob to the appropriate setting.
3. To release negative ions into the filtered air, turn the
Ionizer ( ) Control Knob to ON and the light will
illuminate.
4. The lonizer will not work unless air cleaner is running.
5. For optimum air filtration, it is recommended to
operate the air cleaner continuously. Its rugged
motor has been designed to give many years of use.
REPLACING THE FILTER
IMPORTANT:
• NOTE: DO NOT attempt to wash and re-use the
HEPA filter.
• If the filters are enclosed in plastic bags, remove
before use.
NOTE:
Every few weeks, check the condition of filters. Filter life will
vary, depending on air quality and usage. On average, HEPA
filters need replacement every 10-12 months.
To replace your filter:
1. Turn off and unplug the air cleaner.
2. Open the air inlet grill and examine the foam pre-
filter. Remove any dust or lint, and wash in warm
soapy water. Rinse, drip dry, and place back into grill
inlet.
3. Remove HEPA filter from the unit by pulling it gently
towards you and discard it. DO NOT attempt to
clean the old HEPA filter.
4. Install the new HAPF300 HEPA filter into the unit.This
model utilizes a hang tab and filter clips to insure
that the filter is properly in place. Before replacing
the filter, make sure that the hang tab is securely in
place. The clip can only be attached to the tabs on
the filter one way. The
filter clip should easily
slide onto the filter hang
tab with only a small
amount of pressure. DO
NOT use force while
attaching the clip to the
filter. (Fig. 2)
5. Align the clip on the top
of true HEPA filter with
rails on the inside of the
cleaner unit. Gently slide
the filter onto the rail. (Fig.
3)
6. Replace air inlet grill.
I M P O R TA N T S A F E G U A R D S
F E AT U R E S
O P E R AT I O N S ,
C L E A N I N G / M A I N T E N A N C E
SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire,
electric shock, and injury to persons. These precautions
include:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance
directly into a 120V AC electrical outlet.
3. If the filter is covered by a bag when shipped,
remove plastic bag before use.
4. Keep the cord out of heavy traffic areas. To avoid
fire hazard, NEVER put the cord under rugs, near
heat registers, radiators, stoves, or heaters.
5. To protect against electrical hazards, DO NOT
immerse the appliance in water or other liquids. Do
not use near water.
6. Close supervision is necessary when any appliance is
used by or near children, or disabled persons.
7. Always unplug the air cleaner before moving or
cleaning the unit, opening the grill, changing the filters
and whenever the unit is not in use. To disconnect the
unit, be sure to pull the plug and not the cord.
8. NEVER drop or insert any objects into the openings of
the unit.
9. Do not operate any appliance with a damaged cord
or plug. If the motor fan fails to operate or the unit
has been dropped or damaged in any manner, return
appliance to manufacturer for examination and/or
repair.
10. Use appliance only for intended household use as
described in this manual. Any other use not
recommended by the manufacturer may cause fire,
electric shock, or injury to persons. The use of
attachments not recommended or sold by Jarden
Consumer Solutions may cause hazards.
11. DO NOT use outdoors.
12. NEVER place on a soft surface such as a bed or sofa
as this could cause the unit to tip over and block the
air inlet or outlet grills.
13. Keep unit away from heated surfaces and open flames.
14. DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed
by Jarden Consumer Solutions or an authorized
Jarden Consumer Solutions Center.
15. DO NOT place anything on top of unit.
16. NEVER use detergents, gasoline, glass cleaner,
furniture polish, paint thinner, or other household
solvents to clean any part of the appliance.
17. Always turn the appliance off before unplugging it.
18. The ionizer in this appliance produces less ozone than
the UL established limits of 50ppb. However, in high
concentrations, ozone can be harmful to birds and
small pets. To prevent ozone buildup, we suggest using
the ionizer in well ventilated areas with the fan on.
19. This appliance should only be used in a room with
temperatures between 40° F and 110° F.
20. WARNING: To reduce the risk of fire or electric shock,
DO NOT use this appliance with any solid-state speed
control device.
PLEASE SAVE THESE
IMPORTANT SAFETY
INSTRUCTIONS
PLUG SAFETY
CAUTION: To reduce the risk of electric shock, THIS
PRODUCT HAS A
POLARIZED PLUG (one blade
is wider than the other).
This plug will fit into a polarized
outlet only one way. If the plug
does not fit fully into the outlet,
reverse the plug. If it still does
not fit, contact qualified personnel to install the proper
outlet. DO NOT ALTER THE PLUG IN ANY WAY.
CORD SAFETY
• The length of cord used on this appliance was selected to
reduce tangling or tripping hazards.
• If a longer cord is necessary, an approved extension cord
may be used. The electrical rating of the extension cord
must be equal to or greater than the electrical rating of
the air cleaner (see rating label marked on product).
• Care must be taken to arrange the extension cord so
that it will not drape over the countertop or tabletop
where it can be pulled on by children or accidentally
tripped over.
GET TO KNOW YOUR AIR CLEANER
Your true HEPA air cleaner removes up to 99.97% of
airborne allergens as small as 0.3 microns, including
ragweed pollen, grass pollen, tree pollen, household dust,
dust mite debris, mold spores, pet dander and smoke
from the air passing through the filter.
IONIZER
This appliance has an optional ionizer feature which,
when turned on, releases negative ions into outgoing
filtered air to help the air purification process.
What Are Ions?
Ions are tiny particles that carry a positive or negative
charge. They exist naturally around us: in the air, water,
and ground. Both positive and negative ions are
colorless, odorless, and completely harmless.
How Does The Ionizer Work?
Negative ions help air purification by attaching themselves
to very small airborne particles in the room. These particles
take on a negative charge and may join with positively
charged particles such as dust, pollen, smoke, and pet
dander to form larger particles. These larger particles are
then more easily captured by the filter system.
Important Notes:
Your ionizer may produce an occasional popping or
cracking sound. This is normal and occurs when a small
buildup of ions is discharged.
After extended use, you may notice dust around the grills
or front panel. This is caused by negative ions exiting the
air outlet, evidence of the ionizer’s air cleaning
effectiveness. You can remove the dust with a soft brush
or clean, damp cloth.
Larger particles may be attracted to positively charged
surfaces throughout the home, like walls or floors.
• This may occur more frequently when the filter is
nearing the end of its useful product life and unable
to capture as many charged particles.
• Excessive amounts of pet dander, dust, or smoke
may decrease the life expectancy of the filter and
interfere with the ionization process.
To help prevent particles from attracting to surfaces
throughout your home:
• You may want to run the ionizer less often.
• Check the condition of the filter more frequently.
CAUTION: The ionizer in this appliance produces less
ozone than the UL* established limits of 50ppb. However,
in high concentrations, ozone can be harmful to birds and
small pets. To prevent ozone buildup, we suggest using
the ionizer in well ventilated areas with the fan on.
TRUE HEPA FILTER
HEPA (High Efficiency Particulate Air) filters are
designed to remove up to 99.97% of airborne pollutants
at 0.3 microns or larger, from the air that passes through
them. These include tobacco smoke, household dust, pet
dander and pollen.
HIGH, MEDIUM AND LOW SPEED
SETTINGS
For optimum air filtration, operate your Holmes ® air
cleaner continuously on the HI setting. Its rugged motor
has been designed to give many years of use. For quieter
operation (such as in a bedroom), select LOW setting.
BEFORE USE
1. Carefully unpack your air cleaner.
2. Select a firm, level surface with no obstructions to the
air inlets or outlets.
3. If the filter is covered by a bag when shipped, remove
plastic bag before use and place filters into unit.
*Tested and listed by the Underwriters Laboratories, Inc.
Fig. 2
Fig. 3
Fig. 1
B C
E
A
F
G
D
A. Speed Control Knob
B. Ionizer Control Knob
C. Ionizer Indicator Light
D. Air Inlet Grill E. Washable Foam
Pre-Filter
F. True HEPA Filter
G. Filtered Air Outlet
HAP706_07EM1.qxd 6/19/07 14:14 Page 2