haier XQSB60-JN - Manual (Page 18)

16
The digitron displays E0.
The safety switch acts, and the
spinning cannot work. The
digitron displays E3.
The water filling does not work, or is
slow. After about 30 minutes later,
the digital displays E4.
The drainage cannot work, or is too slow.
The digitron displays E1.
It stops running in midway. The digitron
displays E2.
Is the water tap opened, or is there water
supply failure?
Is the water inlet valve blocked?
The top lid is not closed.
The top lid is opened during reserve
procedure.
Close the top lid.
Close the top lid.
Is the drain hose put down?
Is the drain hose blocked?
Put down the drain hose. Open and close the
top lid once.
Clean the foreign material. Open and close
The top Lid Once.
Are the laundries put slantingly?
Is the machine slanting?
Reorder the laundries. Close the top lid.
Place the machine horizontally. Open
and close the top lid once.
Is the water tap opened, or is there water
supply failure?
Is the water inlet valve blocked?
Is the water pressure too low?
Open the water tap. Push the start/pause
button once.
Clean the water inlet valve then push
the start/pause button once.
Open and close the top lid once..
The water level sensor is bad. Please contact the after-sales
service department.
Is the machine slanting?
Are the laundries put slantingly in spinning?
Are there any foreign materials?
Is the screw of the jointer of water
inlet hose loose or awry?
Adjust the machine to be even
Reorder the laundries and close the top lid.
Remove the foreign materials.
Fasten the screw of the jointer properly.
The water tap leaks
The digitron displays EE.
The digitron displays E6.
There's abnormal sound
inside the machine
Phenomenan The reason How to settle
Trouble-shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns
sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special
maintenance department or after-sale service department of our company. Do not repair it by yourself.
The machine does
not act
Not wash
Not spin
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset position?
Please use it when there's power supply.
Insert the power plug tightly.
Fill water to the preset position.
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Insert the power plug tightly.
Close the top lid.
Set the laundries flat.
Open the water tap. Push the start/pause
button once.
Clean the water inlet valve then push
the start/pause button once.
* The spinning is intermittent when it starts * Balance the laundries to avoid slanting.
* The wash procedure pauses.
Phenomena Explanation
* The cloth sensor is detecting the cloth. It will start adding water
after about 48 seconds.
* Select Spin program, but it doesn t work.
* The program is setting the drain time. A certain period is needed
before it starts spinning.
* The pulsator pauses during washing, rinsing or adding water. * It is to avoid splashing during water filling.
* There may be some water flowing out of the drain hose in the first
use of the machine.
* It is the water remained in the performance inspection by the factory.
* When selecting " No washing powder " or " Disinfect " function,
there is a small quantity of water flowing out of the drainpipe
during water filling.
* When selecting " No washing powder " function, what is expelled
from the drainpipe is disinfector during water filling, which can
sterilized the gully and wiping rags, etc.
* When selecting " Disinfect " function, what is expelled from the
drainpipe is decontaminating water during water filling, which
clean the gully and wiping rags, etc.
Common phenomena