Hawking Technology HWBA54G - Manual (Page 34)

- 29 -
Admin (Administration)
In this Administration page, you can
Change device name.
This is the name that the bridge will use to identify itself to external
configuration and IP-address-finding programs. It is okay to leave this
blank if you are not using these programs
IP address setting.
Set the IP address for this device or use dhcp to get a ip for this device.
Change password.
The device has no password at default. It is recommended that you set a
password to ensure that no one can adjust the device’s settings;
Reboot/Reset this device.
Reboot, the device will re-boot itself and still keep your original
settings. You will probably do this if problems occur with this
access point.
Reset, the device will reset itself to the factory default settings.
(Note that all your original settings will be replaced by factory
default settings.)
To set/change password:
4. Enter your password to the first password box.
5. Enter the password again in the next box to confirm.
6. Click SAVE to save the setting.