Harbor Freight Tools 90749 User Manual
Page 8
SKU 90749
For technical questions, please call 1-800-444-3353.
Page 8
the oil appears in the
middle of the circle
in the Oil Sight Gauge.
(See Figure C.)
3.
If the oil level is below the middle of the circle in the Oil Window (B23), UN-
SCREW (do not pull) the Oil Cap (23) out of the Oil Fill Hole.
Next, add oil into
the Oil Fill Hole until the level of oil reaches the middle of the circle as indicated
in the Oil Window. Do not overfill. Note: Optimal capacity of the oil reservoir is
21.5 ounces.
Then screw the Oil Cap back onto the Oil Fill Hole, being careful
not to strip the plastic threads.
(See Figure C.)
OIL
WINDOW
(B23)
OIL CAP
(23)
FRONT VIEW
SIDE VIEW
FIGURE C
4.
CAUTION: ALWAYS make sure the crankcase of the Gasoline Engine
(5) is filled to the proper level with a
premium quality, 30-weight, non-
detergent engine oil
prior to starting the engine. Failure to do so will result
in damage to the Air Compressor and void its warranty. Refer to the engine
manufacturer’s instruction manual for further information.
5.
Check to make sure the Drain Plugs on both Air Tanks (31) are fully closed.
(See Figures D, and E.)
TYPICAL DRAIN PLUGS
1/4” HEX
PIPE
FIGURE D
6.
Turn the Tool Pressure Valve (13) clockwise all the way to allow compressed air
to build up in the Air Tanks (31). (See Figure B.)
REV 02/04