Hunter Fan 34203 - Manual (Page 7)

©2008 Hunter Fan Co. 41785 Rev 05-06-2008 7
Atomizer
Posts
Pump Cap
Funnel
Pump
Funnel
Pump
Arrows
Pump
Cap
3. Place the Atomizer in the Upper Reservoir, aligning the
three oval holes in the Atomizer with the three prongs in the
Upper Reservoir. The side of the Atomizer with three short
posts should be facing upward. See Figure 17.
Figure 17
4. Assemble the Pump Cap and the Funnel Pump by aligning
the arrows on both components and inserting the Funnel
Pump into the Pump Cap. Twist the Funnel Pump counter-
clockwise until the two components snap together. See
figures 18a and 18b.
Figure 18a
Figure 18b
5. Attach the Funnel Pump Assembly to the Power Pack by
engaging the three tabs on the underside of the fan blade.
See Figure 19.
Power Pack
Funnel Pump
Assembly
Tabs
Fan Blade Under-
side
Figure 19
6. Place the Power Pack into the Upper Reservoir so that the
three prongs in the Power Pack go through all three holes
in the Atomizer and into the three prongs in the base of the
Upper Reservoir. Make sure the Power Pack is securely
seated and all three prongs are in the proper position. See
Figure 20.
Upper
Reservoir
Power Pack
Atomizer
Holes in the
Atomizer
Figure 20
NOTE: The prongs will only fit into the Upper Reservoir one
way.
7. Follow the directions in the section REFILLING THE WATER
TANK to complete reassembly.