Harley-Davidson HDP66 - Manual (Page 7)

5
The remote control battery is already installed at the factory. When the
remote control stops operating or its range seems reduced, it is time
to replace the battery with a new one.
1. The battery door is located on the back end of the remote control.
2. Pull the battery door to release the battery door latch and take out
the battery.
3. Insert a CR2032 battery, checking that the + and – sides of the
battery matches the drawing inside the battery compartment.
4. Replace the battery door.
Note: Make sure you dispose of batteries properly (see your local regulations).
The Remote Control controls basic functions on the HDP-66 and certain
iPod functions when the iPod is docked in the HDP-66.
For best results, aim remote control towards the remote sensor on the middle left of the enter speaker.
WARNING:
• Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to water, fire, or high
temperatures. & not handled appropriately
• Do not place loose batteries in a pocket, purse, or other container containing metal objects, mix with used or other
battery types, or store with hazardous or combustible materials.
• Store in cool, dry, ventilated area.
• Follow applicable laws and regulations for transport and disposal.
To check for iPod compatibility
HDP-66 is an advanced system and supports most updated iPhone/iPod features. To ensure your iPhone/iPod works properly
with the HDP-66, please update your iPhone/iPod firmware with the latest version available via iTunes.
ᕤ
Installing Remote Battery
ᕢ
ᕣ
Install/Replace the Remote Control Battery