Hand Held Products 4X00 Series - Manual (Page 2)

Disclaimer
Hand Held Products, Inc. d/b/a Hand Held Products (“Hand Held Products”) reserves the right to make changes in specifications
and other information contained in this document without prior notice, and the reader should in all cases consult Hand Held
Products to determine whether any such changes have been made. The information in this publication does not represent a
commitment on the part of Hand Held Products.
Hand Held Products shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or
consequential damages resulting from the furnishing, performance, or use of this material.
This document contains proprietary information which is protected by copyright. All rights are reserved. No part of this document
may be photocopied, reproduced, or translated into another language without the prior written consent of Hand Held Products.
©
2000-2005 Hand Held Products, Inc.. All rights reserved.
Web Address: www.handheld.com
Microsoft
®
Visual C/C++
®
, Windows
®
95, Windows
®
98, Windows
®
2000, and Windows NT
®
are either registered trademarks
or trademarks of Microsoft Corporation in the United States and/or other countries.
Other product names mentioned in this document may be trademarks or registered trademarks of other companies and are the
property of their respective owners.
FCC/CE
The IMAGETEAM™ (IT) 4X00 Series Image Engine, integrated into an OEM device, may require testing by the OEM to insure
compliance with the following federal regulations:
47 CFR Part 15
EC’s Electromagnetic Compatibility Directive (89/336/EEC) and Low Voltage Directive (73/23/EEC)
For CE-related inquiries, please contact:
Hand Held Products, Inc.
5627 BT Eindhoven
The Netherlands
LED Eye Safety Statement for IT4000 and IT4100 Series Engines
The IT4000 and IT4100 series engine meets the requirements of a Class 1 Product as specified in IEC 825-1:1993 and EN
60825-1:1994 when tested in a standard IT4410 and IT4710.
Note: It is the OEM manufacturer’s responsibility to comply with applicable regulation(s) in regard to standards for specific
equipment combinations.