Harbor Freight Tools 32222 - Manual (Page 9)

Step 5: Mount the BLADE to the SHARPENING JIG (#63) as shown in Figure 4.
Step 6: Use the angle to keep the edge correct
as shown by the arrow.
Step 7: Sharpen by hand using a fine, metal file
or a whetstone.
Step 8: Remove BLADE from the SHARPENING
JIG.
Setting & Replacing Blades
Step 1: Loosely attach the BACK PLATE
(#20) to the BLADE SET JIG (#62)
as shown in Figure 5.
Step 2: Make sure the edge of the BLADE
(#19) is resting on the front of the JIG.
Step 3: Set the BACK PLATE against the
back of the JIG.
Step 4: Holding both pieces firmly in place,
tighten the two SCREWS (#24).
Step 5: Snap blade assembly back into the
CUTTER BLOCK (#16) as shown
in Figure 6.
Figure 6 — Placing the Blade onto the Cutter Block
Step 6: Replace the BLADE HOLDER (#21) using the three BOLTS (#23).
Sharpening
Angle
Blade
(#19)
Sharpening Jig
(#63)
Screw
(#24)
Blade
(#19)
Back Plate
(#20)
Sharpening
Jig
(#63)
Bolts
(#23)
Blade Holder
(#21)
Screw
(#24)
Back Plate
(#20)
Blade
(#19)
Cutter Block
(#16)
Shoe
Assembly
Figure 5 — Setting the Blades
Figure 4 — Removing the Blade and
Sharpening Jig
Page 9 -- SKU: 32222