Healthrider HRCR91081 - Manual (Page 4)

4
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
• Read each assembly step carefully before you
begin.
• During assembly, make sure that all parts are
oriented as shown in the drawings.
1. Depress the Dual End Snap Button (46) in the
Handlebar (6) and insert the Handlebar into the
Handlebar Swing Arm (5). Make sure that the Dual
End Snap Button seats fully into the indicated holes
in the Handlebar Swing Arm.
5
6
46
Holes
1
2. Press the Magnet w/Bracket (36) onto the Pedal
Frame (4) as shown.
Slide the Monitor (35) fully onto the Main Frame (1)
as shown in inset drawing A. Press down on the
Monitor as shown in inset drawing B until it snaps
into place.
3. Remove the battery cover from the Monitor (35).
Insert two new AA batteries into the Monitor. Identify
the negative (–) and positive (+) ends of the batter-
ies. The negative ends of the batteries should touch
the springs in the battery compartment. .
2
35
1
36
4
A
B
3
35
Battery
Cover
AA
Batteries
(–) (+)