Henny Penny COLD TOPS CMC/CMR-104 - Manual (Page 6)

Model CMC/CMR-103,104,105,106,107
2-1. INTRODUCTION This section provides the installation for Henny Penny cold tops.
Installation of this unit should be performed only by a
qualified service technician.
Do not puncture the unit with any objects such as
drills or screws, or component damage or electrical
shock could result.
2-2. UNPACKING The Henny Penny Cold Top has been tested, inspected, and
expertly packed to insure arrival at its destination in the best
possible condition. The grids, side glass, and sliding thermal doors
are packed separately inside the unit. The cabinet rests on a
wooden skid and is then packed inside a heavy cardboard carton
with sufficient padding to withstand normal shipping treatment.
To avoid damage to the components, do not lay the unit
on its side. If the unit has been on its side, the unit must
be in an upright position for at least 4 hours before power
is applied to the unit.
Check all components, for signs of being loose or dam-
aged, and make sure the system has refrigerant.
When moving the cold top be careful not to damage the
refrigerent circuit.
Any shipping damage should be noted in the presence
of the delivery agent and signed prior to his or her
departure.
To remove the Henny Penny cold top from the carton:
1.
Carefully cut banding straps.
2. Lift the carton off the unit.
3. Remove bolts securing the cold top to the skid and lift the
unit off the skid.
303 2-1
SECTION 2. INSTALLATION