HONDA HHE31C - Manual (Page 23)

SERVICING YOUR HONDA STICK EDGER
21
Engine Oil Recommendations
Oil is a major factor affecting performance
and service life. Use 4-stroke automotive
detergent oil.
SAE 10W-30 is recommended for all
temperatures within the recommended
operating range for these stick edgers. The
recommended operating range extends from
23
°
F (-5
°
C) to 104
°
F (40
°
C).
The SAE oil viscosity and service classification
are on the API label on the oil container. Honda
recommends that you use API SERVICE
category SH or SJ oil.
Air Filter
Inspection
Squeeze the air cleaner latch tabs, and remove
the air cleaner cover. Check the filter to be sure
it is clean and in good condition.
If the filter is dirty, clean it as described
in the next section. Replace the filter if it is
damaged. Reinstall the filter and air
cleaner cover.
NOTICE
Operating the engine without an air filter, or with
a damaged air filter, will allow dirt to enter the
engine, causing rapid engine wear. This type of
damage is not covered by the Distributor's
Limited Warranty.
Cleaning
A dirty air filter will restrict air flow to the
carburetor, reducing engine performance. If you
operate the engine in very dusty areas, clean
the air filter more often than specified in the
MAINTENANCE SCHEDULE.
1. Clean the air filter in warm soapy water,
rinse, and allow to dry thoroughly. Or clean
in nonflammable solvent and allow to dry.
2. Dip the air filter in clean engine oil, then
squeeze out all excess oil. The engine will
smoke when started if too much oil is left in
the filter.
3. Wipe dirt from the air cleaner base and
cover using a moist rag. Be careful to
prevent dirt from entering the carburetor.
FILTER
AIR CLEANER
COVER
LATCH TABS
RETAINING TABS