Heath Zenith Decorative Wireless Chime 598-1000-07 - Manual

© 2008 HeathCo LLC 598-1000-07
1. Install alkaline type A23 12 volt
push button battery (included).
Remove back of case by push-
ing in tab on bottom with a small
screwdriver (see Figure 1). See
diagram inside push button for
correct battery orientation. Note: If
batteries are preinstalled, remove
orange battery tab.
2. Remove chime cover. Use a
small screwdriver to pry the cover
tabs away from chime base and
remove cover (see Figure 2). Note:
To remove the cover after base is
mounted, firmly grasp cover and
pull.
3. Install 3 alkaline “D” batteries.
Make sure batteries are oriented
properly (see Figure 3).
This package includes (Style of push button and chime may vary from illustration):
• Wireless chime
• Wireless push button with battery
• Hardware pack
This chime requires 3 “D” alkaline batteries (not included). In typical use,
alkaline batteries will last up to three years.
6155 and 6250 Series
Decorative
Wireless Chime
Figure 1
WARNING: To prevent possi-
ble SERIOUS INJURY or DEATH:
• NEVER allow small children
near batteries.
• If battery is swallowed, imme-
diately notify doctor.
Figure 2 - Back of Chime
Horizontal
Keyhole
Vertical
Keyhole
Mounting Holes
Chime Cover Tab (x4)
Chime
Volume
Jumpers
Figure 3 - Inside Chime
Type “D” Type “D” Type “D”
C him
e Volum e