Harbor Freight Tools 91309 - Manual (Page 5)

Page 5 SKU 91309 For technical questions, please call 1-800-444-3353.
Connecting the system (continued)
Operation (continued)
1. Set the Monitor (2) in a dry, stable position, out of the direct sunlight and in accordance with
the operational warnings above. Set the Sunshade (8) on top of the Monitor (2). Just a few
feet from the Camera (1), run the 65 Foot Cable (3) around a railing or post to keep the
weight of the Camera (1) from dislodging the Monitor (2) from its stable position. Plug the
65 Foot Cable (3) into the Camera port (C1) on the back of the Monitor (2). Refer to
FIGURE 2 on page 4,
2. Set the Battery (4) in a dry position, on a plate or other flat, stable surface out of the sun,
close enough for the Battery Cord (5) to reach the rear of the Monitor (2). Attach the Black
(-) alligator clip on the Battery Cord (5) to the Black (-) terminal on the Battery (4). Attach
the Red (+) alligator clip on the Battery Cord (5) to the Red (+) terminal on the Battery (4).
Plug the other end of the Battery Cord (5) into the DC 12 Volt In input on the back of the
Monitor (2).
3. Set the VCR/Camera switch (on the back of the Monitor (2)) to Camera.
4. Turn on the POWER button on the front of the Monitor (2). See FIGURE 3 below.
FIGURE 3
5. Push the Camera button (above) in, if using the C1 Camera input, and leave it out if using
the C2 input. You should see an image on the Monitor (2).
If not, recheck your connections.
Note: The Ballast (see FIGURE 4) can be
set so that the Camera (1) can be set to
have no angle, or angled slightly down
or up. Slightly open the bracket on
the Camera (1) to tilt the Ballast.
6. Gently lower the Camera into the wa-
ter and reel out the 65 Foot Cable (3)
until it is at the appropriate depth.
7. Adjust the Brightness (BRI.) and Contrast
(CONT.) on the front of the Monitor (2). See
FIGURE 3. If additional light is needed, push on the (LED) switch on the front of the
Monitor (2). You can dim the LED lights with the DIMMER switch.
8. When you are finished, remove the Camera (1) from the water, turn off the POWER switch
on the Monitor (2), disconnect the alligator clips on the Battery Cord (5) from the Battery
(4), and unplug the Battery Cord (5) from the Monitor (2).
Warning!! Always keep the Camera (1) and Battery (4) dry and protected from the
elements. Never try to disassemble the Camera’s (1) waterproof housing.
FIGURE 4
Camera (1)
Bracket
Ballast